Philips GC7000 Series Bedienungsanleitung Seite 8

ENGLISH
10
Problem Possible cause
The iron leaves a The surface to be ironed
shine or an was uneven, for instance
imprint on the because you were
garment. ironing over a seam or a
fold in the garment.
The ironing Steam has condensed
board cover on the ironing board
becomes wet or cover after a long ironing
water droplets session.
come out of the
soleplate.
You may have an ironing
board that is not
designed to cope with
the high steam rate of
the steam generator.
Steam continues Steam is generated in
to come out after the soleplate. When you
I release the release the steam trigger,
steam trigger. remaining water is
transformed into steam.
This is normal.
There is a strong When the iron is tilted
gush of steam upwards, remaining
when I release water is collected and
the steam trigger converted into strong
after placing the steam. This is normal.
iron on the iron
platform.
Steam is weak. You do not press the
steam trigger
continuously.
You use the ECO mode.
Steam does not Water is converted into
come out steam in the soleplate.
immediately When you press the
when I press the steam trigger, it will take 1
steam trigger. to 2 seconds until steam
is generated and
released. This is normal.
Solution
Perfect Care is safe on all
garments. The shine or imprint is
not permanent and will disappear
when you wash the garment. Avoid
ironing over seams or folds or you
can place a cotton cloth over the
area to be ironed to avoid imprints.
Replace the ironing board cover if
the foam material has worn out.
You can also add an extra layer of
felt material under the ironing
board cover to prevent
condensation on the ironing board.
Put an extra layer of felt material
under the ironing board cover to
prevent condensation on the
ironing board.
Release the steam trigger 2 to 3
seconds before you place the iron
back on the iron platform or ironing
board.
Release the steam trigger 2 to 3
seconds before you place the iron
back on the iron platform or ironing
board.
Keep the steam trigger pressed
continuously when you move the
iron over the fabric.
For more steam, switch off the ECO
mode by pressing the ECO button.
The green ECO light goes off.
Keep the steam trigger pressed
continuously when you move the
iron over the fabric.