Safety Measures; Vacuum Cleaner Assembly; Operating Instructionsi; Turning On/Off - Fieldmann FDU 200601-E Bedienungsanleitung

EN 18
Important safety instructions | Safety measures | Vacuum cleaner assembly
EN 12 Important safety instructions | Safety measures | Vacuum cleaner assembly
Operating instructions
Never vacuum-clean liquids, flammable or explosive substances such gasoline, and do not
use the vacuum cleaner near such substances.
When you need to reel the cord, hold its plug firmly in your hand. During cord reeling do not
leave its plug to flutter freely in the air.
Before you put on the vacuum-clean hose, first pull out the plug from mains socket.
Never use the vacuum-cleaner without installed dust bag and/or filter.
A damaged supply cord of this appliance must be, for safety reasons, replaced by the service
department of the manufacturer.
This appliance is not designed for being operated by the persons (including the children of
up to 8 years of age) with limited physical, sensory and mental abilities or by the persons with
insufficient experience and/or knowledge. The operation of this appliance by those persons
is only possible assuming their safety is overseen by a competent person or this person
instructs them how to operate this appliance. Children must be under supervision to make
sure they do not play with the appliance.
This vacuum cleaner is intended just for dry vacuum-cleaning.

5. SAFETY MEASURES

Never vacuum-clean hot embers, burning items or the items with temperature
exceeding 40 °C (104°F).
Make sure your hands are dry and only then connect the plug into mains socket.
Never disconnect the appliance from mains by pulling power cord, always disconnect it by
pulling the plug.

6. VACUUM CLEANER ASSEMBLY

Before assembly or disassembly of accessories individual parts always first disconnect the plug
from mains socket.
Prepare all accessory parts (Fig. 2/A).
Put the tube on the hose handle (Fig. 2/B).
Assemble the flexible hose according to the figure and insert its ending with a connector into
the suction hole on vacuum cleaner upper side. Push inwards and a click is heard at the right
position (Fig. 2/C).
Connect wheels (Fig. 2/D).
7. OPERATING INSTRUCTIONS

Turning on/off

The vacuum cleaner turns on using the ZAP/VYP switch (ON/OFF) (Fig. 3).
(FIG. 6)
(FIG. 2)
FDU 200601-E
FDU 2001-E