Installation; Charging Battery - Gembird ACAM-001 Benutzerhandbuch

Night mode Night off
SELF TIMER_MENU
Play back mode
SD card protect
C: Recording capacity
1G
1920*1080(FPS30) 21min
1280*720(FPS30) 30min
848*480(FPS60) 30min
12M 239photos
8M 367photos
5M 517photos
3M 614photos

1: Installation

1.1 Installation of battery
1. Slide down the battery cover and open the device.
2. Follow the instructions of the logo on battery +/- sign, then put the battery into the camera battery
slot until it is installed.
3. For battery capacity information, please refer to the displayed battery icon:

1.2 Charging battery

1. Using the USB cable: connect the device to the USB port of a computer/Laptop
2. Using the car changer: Connect the device to the car charger. The device will start charging after the car engine is
turned on. The device will automatically turn on and start recording. When the engine stops, the device will
automatically save the last file and turn off.
Normally it takes approximately 2-3 hours to fully charge the device. Operating the device while charging will extend
the total charging time of the battery.
Note: before using the device for the first time, please first fully charge the Li-ion battery.
GEMBIRD EUROPE B.V. http://www.gembird.eu
FULL HD ACTION CAMERA WITH WATERPROOF CASE
Night on
SELFTIMER_5
playing
2G 4G
42min 85min
63min 128min
63min 128min
478photos 956photos
739photos 1486photos
1040photos 2092photos
1235photos 2484photos
SELFTIMER_10 SELFTIMER_Off
8G
172min
266min
266min
1912photos
2988photos
4208photos
4996photos
ACAM-001
4