Before Use; During Use; After Use - Silva CROSS TRAIL 2X Handbuch

FULL VERSION MANUAL
CROSS TRAIL 2X
Thank you for choosing Silva Cross Trail 2X headlamp. This headlamp, thanks
to the modular design, can also be used on a helmet or on a bike handle bar.
The Cross Trail 2X headlamp is equipped with Intelligent Light® which is a
light distribution technology that combines a wide angle flood light with a long
reach spot light. This unique light image gives the user peripheral and long dis-
tance vision at the same time. For a runner, cross country skier, mountain biker
or night orienteer this translates into less head movement, increased control,
better balance and more speed.
PRODUCT OVERVIEW
The Cross Trail 2X headlamp consists of the following parts:
• Headlamp body
• Headband
• Helmet bracket with adhesive strip
• Bike bracket
• USB charge cable
• Li-Po battery in rubber skin
• Battery case with attachment strap
• Quick guide

BEFORE USE

BATTERY CHARGING
The battery needs to be charged before first use.
1. Disconnect headlamp from Battery
2. Open the rubber lid on the battery pack side and insert the micro USB con-
nector on charge cable.
3. Insert the USB connector in a USB-port
4. On the battery there is an LED showing the battery status during charging:
- red light = battery is charging
- green light = battery is fully charged
Battery charging time is approximately 4hrs hours.
Note! When the battery is fully charged the battery automatically switches
off charging. However, never leave the battery connected to a USB-port unat-
tended for longer periods.
ADJUST THE HEADBAND
The elastic headband is designed to give a comfortable fit at speed during acti-
vities such as running, XC skiing etc. Adjust the headband by moving the sliding
buckle to fit it onto your head.
FLEXIBLE BATTERY CARRYING
The battery pack can be carried in multiple ways; for example on the head band,
in a pocket, backpack, on the waist or mounted on the bike frame by using the
soft case with the integrated strap.
MODULAR SYSTEM
In order to move the headlamp body from the headband to either the helmet
bracket or the bike bracket, gently press the release button (located on top of
the headlamp on the left hand side) forward while lifting the headlamp body.
Insert the headlamp body in the bracket and gently press it down until you hear
a click sound.
MOUNTING THE HELMET BRACKET
The helmet bracket comes with pre mounted adhesive on the back for easy
mounting on any helmet. The adhesive is a polyethylene foam tape developed to
not damage or cause any type of weakness to plastic.
Before mounting the helmet bracket on a helmet, make sure the surface is dry
and clean. Remove the protective paper from the adhesive tape on the helmet
bracket. Gently press the helmet bracket to the helmet.
MOUNTING THE BIKE BRACKET
The bike handlebar bracket is developed for use on bike handlebars with a di-
mension between 25 and 32 mm. Included with the bike handle bar attachment
are 3 rubber inserts. Use these to ensure the correct fitting for your bike and
tighten the bottom screw to secure it on to the handlebar.

DURING USE

SWITCH ON YOUR HEADLAMP
On the side of the headlamp body there is a push button which controls all light
modes.
Available light modes: Max, Mid, Min, Wide, Blink
Each press on the button gives you the following light:
1. Turns the headlamp ON with all LEDs in maximum power.
2. Goes to Mid mode
3. Goes to Min mode
4. Goes to Wide mode
5. Starts over from 1 – Max mode
To turn OFF the headlamp; press and hold the button for 2 seconds.
The flash function, which is used to attract attention, is started from OFF mode
by pressing and holding the button for 2 seconds. To turn OFF; press and hold
the button for 2 seconds.
Art.no 39024-3
TEMP CONTROL
The headlamp temperature will increase during use. The headlamp tempera-
ture is mainly depending on light mode, ambient temperature and the airflow
(speed). The Cross Trail 2X headlamp is equipped with a temperature control
function which prevents the headlamp body from overheating by reducing the
power to the LEDs. This means that the lower the ambient temperature, the
stronger the light output.
Note: Always make sure that the batteries are disconnected when the head-
lamp is stored in a closed compartment such as a bag, pocket or similar.
BATTERY INDICATION
When the headlamp is turned off a small LED is turned on inside the front of the
headlamp to indicate the status of the batteries. The battery status indication
LED will be on for 5 seconds after power off.
Green light – Battery in good condition (more than ~70% remaining)
Red – Battery in poor condition (less than ~30% remaining)

AFTER USE

MAINTENANCE
To make sure you get maximum performance from your Cross Trail 2X head-
lamp, clean it regularly with a damp cloth.
Headset cleaning – wash in washing machine at 40º C.
ABOUT LI-ION (LI-PO) BATTERIES
The battery should be stored in a dry environment within the temperature
range of -20°C and +35°C.
If you would like to store your battery for a longer period (more than 30 days)
the battery should not be fully charged. This may cause loss of its characte-
ristics.
Li-Ion batteries have a discharge rate of approx. 20% over a 30 day period. You
can always charge a half full battery without damaging its characteristics.
Do not expose the battery for extreme temperatures which may cause fire or
explosion.
Do not disassemble or mistreat the battery as there is a risk of chemical burn.
Keep away from children.
Do not dispose of batteries in fire. This may cause an explosion.
Do not submerge the batteries in water.
Do not short circuit the contacts.
Replace only with a Silva battery.
Note! Always make sure to disconnect the battery when the headlamp is not
used.
TECHNICAL SPECIFICATIONS
Weight: headlamp (including head bracket and battery): 170g
Battery type: Li-Ion 7,4V 900mAh
Light distance (Max/Min/): 120m/20m
Lumen (Max): 300 Lumen
Burn time: Max/Mid/Min/Wide/Blink: 2h/4h/5h/14h/10h
Water resistance: IPX6
Material head lamp body: PC/ABS and Aluminium
Operative temperature range: -10º - +60º C
Storage temperature range: -20 - +35ºC
Art No: 39024-3
PROTECT THE ENVIRONMENT.
Headlamp and batteries should be recycled and must not be thrown in the
regular trash. Dispose these items in accordance with applicable local regu-
lations.
WARRANTY
Silva warrants that, for a period of two (2) years, your Silva Product will be
substantially free of defects in materials and workmanship under normal
use. Silva's liability under this warranty is limited to repairing or replacing
the product. This limited warranty extends only to the original purchaser. The
rechargeable Li-Po/Li-Ion battery is not covered by the product warranty
period. The warranty period of the Li-Po/Li-Ion battery is 1 year.
If the Product proves defective during the Warranty Period please contact
the original place of purchase. Make sure to have your proof of purchase on
hand when returning the product. Returns cannot be processed without the
original proof of purchase. This warranty does not apply if the Product has been
altered, not been installed, operated, repaired, or maintained in accordance
with instructions supplied by Silva, or has been subjected to abnormal physical
or electrical stress, misuse, negligence or accident. Neither does the warranty
cover normal wear and tear. Silva is not responsible for any consequences,
direct or indirect, or damage resultant from use of this product. In no event
will Silva's liability exceed the amount paid by you for the product. Some juris-
dictions do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitation or exclusion may not apply to you. This War-
ranty is valid and may be processed only in the country of purchase.
For more information please visit www.silva.se
Visit: www.silva/enviroment
for more information about the
Waste Electrical and Electronic
Equipment (WEEE) Directive.