B.A. International BA Optima E+ Bedienungsanleitung Seite 13

2. Sterilization
Sterilization product list
• Angle handpiece
Sterilization Method
• Dry the applicable product completely after cleaning.
• Put the applicable product in a sterile bag and seal tightly.
• Put the sterile bag in the sterilizer and sterilization for 4 minutes
with 132 °C, and let it dry for 30 minutes.
3. Lubrication
Lubrication product list
• Angle handpiece
Lubrication Method
• Insert the spray nozzle to motor assembly part (the end part of
angle) and spray lubricant 2~3 seconds.
• Insert the nozzle tip to head part and spray lubricant 2~3 seconds.
Warning
• Do not lubricate the motor section of the motor handpiece.
• To clean the motor handpiece, do not use any solvent such as benzene and/or a thinner.
• Before mounting the lubricated contra angle head to the motor handpiece, wipe off extra oil. Stand on its end or lean it in the proper position
for gravity draining. Mount it after excess oil has been drained.
• Hold the contra angle head securely to prevent it from fl ying off by the pressure of the spray.
• Supply lubricant until it comes out of the handpiece head (for approx. 2 seconds.)
• Do not use a spray can upside down. In such a case, only spray gas comes out and oil is not sprayed.
• Do not clean with aldehydes for the plastic component.(Charging Station, Motor handpiece)
BAE370R_IFU-Final.indd 13
132 °C
Sterilization Temperature
Moist heat 132 °C
sterilization
Notice
• The nozzle tip and spray nozzle are not provided by manufacturer.
• If the continuous operation, please put the oil every an hour.
• When lubrication, please hold the handpiece fi rmly because the
handpiece can go out by the spray pressure.
Time Drying
time
4 minute 30 minute
13
02/04/2019 12:22:33