MA grandMA3 onPC Kurzanleitung Seite 16

grandMA3 onPC command wing front panel
1. Dual encoder section
2. Level wheel
3. Command section
4. Master section
5. Executor buttons
6. Executor faders
7. Executor buttons
8. Executor knobs
Connect and Power Up the Device
1. Unpack the device.
2. Remove the packaging and cushioning material.
3. Place the device indoors on a stable surface.
4. Download the grandMA3 onPC software on www.malighting.com
5. Install the software on your PC or laptop. For minimum requirements see System Requirements grandMA3 in the grandMA3
user manual.
6. Connect the grandMA3 onPC command wing with your PC or laptop using a USB cable.
7. Start the grandMA3 console or grandMA3 onPC.
8. Switch on the grandMA3 onPC command wing:
-Insert IEC connector into the corresponding jack.
-Connect the main power plug.
-Turn on the power switch:
-Set it to position I.
-The power switch lights up in red.
To turn off the grandMA3 onPC command wing set the power switch to position O.
17
Intended Use
Safety
Support
Transport
Limitations
Quick Start
Maintenance
Disposal
Technical Data
Declaration of Conformity