Manual Release Instructions - Entrematic Ditec Qik4E Technisches Handbuch

Manual release instructions

In the event of a fault or power failure, insert the key, turn it anticlockwise and completely open
the hatch. Manually open the barrier.
To block the barrier again, close the hatch, turn the key clockwise and remove the key.
WARNING: do not release with the springs under tension without bar. Perform bar locking and release
with the motor switched off. Do not enter the operating range of the bar. When the barrier is released,
the bar may move of its own accord.
When the hatch is closed but the key is still horizontal, the release microswitch is open and all ma-
noeuvres are prevented.
To deactivate the barrier, the power supply must be removed and the batteries disconnected (if present).
For any problems and/or information, contact the support service.
Installer's stamp
Intervention performed
Entrematic Group AB
Lodjursgatan 10
SE-261 44, Landskrona
Sweden
www.ditecentrematic.com
1
Operator
Date of intervention
Technician's signature
Customer's signature
40
2