Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Rated Power (2 x 2 Ohms)
Rated Power (2 x 4 Ohms)
Rated Power (2 x 8 Ohms)
Minimum Load Impedance
Maximum RMS Voltage Swing
Frequency Response
Power Bandwidth
T.H.D. (2 x 2 Ohms)
T.H.D. (2 x 4 Ohms)
T.H.D. (2 x 8 Ohms)
Input CMRR
Voltage Gain
Crosstalk
Hum and Noise
Power Consumption
Slew Rate
Damping Factor (8 Ohms)
SMPTE IMD
Input Sensitivity (x 40)
Input Impedance
Current Draw @ 1/8 power@ 2 Ohms
Cooling
Controls
Indicator LEDs
Protection
Connectors
Construction
Dimensions
Weight
GPS
™
2600 SPECIFICATIONS
- 1,300 Watts @ 1 kHz both channels driven at <0.15% T.H.D.
- 950 Watts @ 1 kHz both channels driven at <0.1% T.H.D.
- 650 Watts @ 1 kHz both channels driven at <0.1% T.H.D.
- 2 Ohms
- 93 Volts
- 10 Hz - 100 kHz; +0, -.3 dB at 1 Watt
- 10 Hz - 40 kHz; +0, -3 dB at rated power
- <0.15% @ 1050 Watts from 20 Hz to 20 kHz with both channels driven
- <0.1% @ 900 Watts from 20 Hz to 20 kHz with both channels driven
- <0.1% @ 600 Watts from 20 Hz to 20 kHz with both channels driven
- > - 65d B @ 1 kHz
- x 40 (32 dB)
- > -75 dB @ 1 kHz at rated power @ 8 Ohms
- > -110 dB, "A" weighted referenced to rated power @ 8 Ohms
- > 1200 Watts
- > 40V/us
- > 700:1 @ 20 Hz to 1 kHz
- <0.1% 60 Hz and 7 kHz, 900W @ 4 Ohms
- 1.54 Volts for 4 Ohm rated power, 1.27 Volts for 2 Ohm rated power
- 20 k Ohms, balanced
- 10 A @ 120 Volts
- Two 80 mm DC fans, off until heatsinks reach 45
variable speed
- Two front panel attenuators
- Two Clip, two Signal, two Active
- Thermal, DC, turn-on bursts, subsonic, incorrect loads
- XLR input, 6.3 mm phone type output patch, Speakon and Binding Post speaker
output, IEC mains input
- 16 ga. steel reinforced with 12 ga.rack ears
- 133 mm x 483 mm x 432 mm, 400 mm behind rear mounting ears
(5.23" x 19" x 17", 15.75" behind rack ears)
- 45.7 lbs. (20.7 kg)
Specifications subject to change without notice.
17
0
C, then temperature dependant
Werbung
