Sangean DPR-26BT Bedienungsanleitung Seite 26

Pairing additional devices
Before pairing another device to the radio, you need to make the radio discoverable.
. Press and hold the Bluetooth pairing /Auto tune button to allow DPR-6BT discoverable for
pairing with other Bluetooth device. The display will now show 'Bluetooth discoverable' for a
few second followed by 'Bluetooth Pairng.' The Bluetooth icon (
. Activate Bluetooth on your device according to the device's user manual to link to the speaker.
Locate the Bluetooth device list and select the device named 'DPR-6BT.' With some mobiles
you may need to input the pass code "0000".
. Once connected, the screen should say ' BT Connected' with your Bluetooth device model
shown on the display and the Bluetooth icon will remain lit.
Bluetooth device memory and reconnecting a device
If your Bluetooth device already paired with DPR-6BT previously, the unit will memorize your
Bluetooth device and it supports the automatic reconnection.
DPR-6BT can memorize up to 8 sets of Bluetooth device, when the memory exceeds this
amount, the earliest paired device will be erased from the radio.
To reconnect to a previously connected device, press and release the Pair button to enter the
Bluetooth device memory. Then rotate the Tuning control to find the desired memorized Blue-
tooth device and press the Select button to connect to the required Bluetooth device.
Disconnecting your Bluetooth device
Press the Band button to switch to any bands other than Bluetooth band or disconnect the Blue-
tooth-enabled device. Alternatively, press and hold the Pair button. Now the Bluetooth icon will
start to flash indicating the radio is discoverable for other devices.
5
) on the panel will flash.
Bluetooth
Pairing...
1
Switch to 1:
Xperia acro S
Switch to 2:
MOTO ME860
Bluetooth
Pairing...