FlexiForce RS70 Montage / Wartung / Benutzung Seite 31

manual
7. Check the panels on damage, wear and roust
8. Check the spring breaking device acc. to instructions in manual
9. Check and test the safety edge system with operator
10. Check the manual operation of the door
11. Grease the springs
After two years (or after every 3000 cycles):
1. Grease all the above mentioned points
2. Check or test the fixation of the springs to the fittings
2. Check the balance of the door and adjust if needed
3. Check the cables for damage or wear and tear
4. Check the cable connection points on drums and bottom bracket
5. Check the roller on wear and free moving space
6. Check the hinges on breaking
7. Check the panels on damage, wear and roust
8. Check the spring breaking device acc. to instructions in manual
9. Check and test the safety edge system with operator
10. Check the manual operation of the door
11. Grease the springs
12. Check side seals on damage or wear and tear
13. Check top seal on damage or wear and tear
14. Check bottom seal on damage or wear and tear
` 15. Check the shaft on wear and tear or damage
16. Check the bottom bracket on wear and tear and damage
17. Check the connection of the drum to the shaft (keys!)
18. Check and re-fix the bolt of the coupler
19. Check the connections of the track system
20. Check the suspension of the door to the lintel and ceiling
Use for greasing
Use for cleaning
GB
rev.0 Feb-09
: PTFE or SAE20 or WD40
: Soft soap with water. Do not use aggressive soap or cloth.
RS70 manual GB 2009
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
MECHANIC
www.flexiforce.com
30