Programmes; Cycle Parameters; Parameters For Soak, Prewash, Wash Or Rinse Cycles - Primer LP-08 Bedienungsanleitung

•
Manual water inlet: This section can be accessed, the state of each water inlet (ON /OFF) is
displayed, and the required inlet can be activated/deactivated. The water inlet that has been activated
by the fill logarithm cannot be deactivated. On exiting the water inlet window, all the manually
activated water inlets will be deactivated.

3 PROGRAMMES

There is a programme library consisting of all the programmes installed by default, together with the programmes
created by the user.
Before explaining the programme management (see section 4.1), details are given of their parameters and of the
standard programmes found in the library.

3.1 Cycle parameters

Each programme is made up of a series of cycles, consisting of a set of parameters which can be configured,
depending on the cycle type in question.
3.1.1

Parameters for soak, prewash, wash or rinse cycles:

•
Cycle name: Name identifying the cycle. This is not the text displayed on the Run screen, but the text
which identifies a created cycle.
•
•
•
Range can be configured from 20ºC (68ºF) to 90ºC (194ºF).
section 4.2). There are 5 types of level: Minimum (1), Low (2), Medium (3), High (4), Maximum (5)
•
Please refer to table of levels by model
•
are 4 different speeds to select from: Minimum (1), Low (2), Normal (3), High (4).
•
/ stop time (seconds)). Range can be configured from 1 to 99.
The drum alternately turns to the left and to the right..
10
Time: Value, in minutes, of the cycle length. Range can be configured from 1 to 99.
Temperature: Temperature, ºC or ºF, of current cycle.
Level: Water level at which cycle should be run. Ranges which can be configured (see
Speed: Speed of current cycle Ranges which can be configured (see section 4.2). There
Wash rate: Sequence of movement that washing machine must follow (run time (seconds)
(see section 4.4.). Range can be configured.