Maintenance; Warranty - Felisatti JS85/701 Bedienungsanleitung

speed.
45° ANGLED CUTTING
The straight blade should always be fitted for angled
or shaped cutting operations.
For circular cuts, use the overturned side cutting
regulating device, with the end bit positioned at the center
of the circle that is to be cut.
For 45° angled cuts to the right or to the left, incline
the base plate.
SIDE GUIDE
If cutting operations need to be carried out at a preset
distance from a 90° rabbet, the special side guide (Fig.1-2)
(supplied with the machine) can be fitted.
The guide should be inserted sideways into the base
plate housing. In order to fix the distance from the desired
edge, tighten the flathead screws located on the base.
SHAVINGS SUCTION UNITS
In order to keep working areas clean and dust free,
the machine has been fitted with a suction pipe union.
To carry out this operation, connect a corrugated pipe
to this union.
IMPROPER USE
The functions and use of this tool are those exclusively
indicated in this manual.
Any other use of the tool is explicitly forbidden!

MAINTENANCE

Regular inspection reduces the necessity for
maintenance operations and will keep your tool in good
working condition. The tool bearings and gears are life-
long lubricated, however it is advised to check the condition
of the grease in the head every 100 hours, if necessary
replace the grease. The motor must be correctly ventilated
during tool operation. For this reason avoid blocking the air
inlets with hands.
The movable needle on the blade support should be
periodically lubricated with a few drops of oil.
After use disconnect the tool from the power supply
and clean carefully.
DISPOSAL
At the end of the machine's working life, or when it
can no longer be repaired, ensure that it is disposed of
according to the standard regulations of the country in
which it is being used, and that the disposal operation is
carried out by specialized personnel following authorized
guidelines.
In all circumstances:
- Do not abandon in the environment;
- Do not dispose of together with solid urban waste
products;
- Contact the special recycling centers.
PARTS REPLACEMENT
ATTENTION! Disconnect the plug from the power
supply socket before replacing any parts.
BRUSHES
The brushes must be replaced after approx. 100
working hours, or if they are less then 5-6 mm in length.
Attention! For correct tool operation always
change the brushes in pairs, not separately. The use
of original Felisatti spare parts is recommended.
Given the difficulty of this operation, it is advised
that it should only be performed by an authorized service
center.
ATTENTION: After fitting new brushes allow the motor
to run idle for 5 minutes.
REPLACING THE POWER SUPPLY CABLE
Check that the power supply cable is in good condition, if
not have it replaced by an authorized service center.
REPLACEMENT OF BLADES
For perfect operation and optimal tool performance,
only use original Felisatti blades. In order to fit the blade,
insert the shank of the saw into the slot located on the
lower part of the gauge block on the saw support shaft,
push the blade up into position, locking in place with the
special spanner, the hexagonal headed screw should be
positioned on the side of the block. The hexagonal key is
provided with the machine and is inserted in a hole on the
suction sleeve, fitted on the support plate.

WARRANTY

See general warranty conditions printed on the
attached sheet.
NOISE AND VIBRATION
This tool has been designed and made to reduce
noise to a minimum. However, in spite of this, in certain
circumstances the maximum noise level in the place
of work could exceed 85 dBA. In this case, the operator
should wear ear protection.
The machine's noise and vibration levels, measured in
compliance with EN 60745, usually reach:
Acoustic pressure = 90 dB(A)
Sound-power level = 101 dB(A)
Use ear protection!
Vibration acceleration = 4,0 m/s²
7