Calibrating The Room Sensor; Changing The Domestic Hot Water Temperature - De Dietrich AD254 Installations-, Bedienungs- Und Wartungsanleitung

AD254 - AD285
1 2 3 4 5
1 2 3 4
%
0 2 4 6 8 10 12 14
MODE
C002436-B
%
+
%
0 2 4 6 8 10 12 14 16 18 20
MODE
A000852-B
+
MODE
13/02/2013 - 300020537-001-03
3. All of the days flash. The new programme will be active every day
6 7
5 6 7 4. Turn the rotary button to the left until 0.00 is displayed. The first
16 18 20 22 24
5. b : Comfort mode selection
3x
6. To return to the principal display, press the MODE key or wait 20
3.2.3.
1. Measure the room temperature with a thermometer.
2. Press key Cx and Vc simultaneously for 5 seconds.
5"
C002430-B
3. Turn the rotary button to set the room temperature.
22 24
4. To confirm, press the rotary button.
°C
3.2.4.
In the factory, the domestic hot water temperature is set to 55°C. Setting
can be done from 10 to 80°C in steps of 1°C.
To modify the domestic hot water temperature, proceed as follows:
1. Press the MODE and r keys simultaneously for 5 seconds. The 1
5"
A000857-A
of the week.
To modify the programme for a particular day, press the rotary button
several times until the desired day flashes.
segment of the graphic bar for the timer programme flashes.
Press the Cx key. The symbol b is steady, the selection mode for
the comfort time ranges is active.
To select a comfort time range, turn the rotary button to the right.
The zone selected is displayed under b on the graphic bar.
v : Reduced mode selection
Press the Cc key. The symbol v is steady, the selection mode for
the reduced time ranges is active.
To select a reduced time range, turn the rotary button to the right.
The zone selected is displayed under v on the graphic bar.
seconds.

Calibrating the room sensor

The symbol CAL and the current temperature are displayed.
Setting is done in steps of 0.1°C. The correction range is between
+ and -5 °C compared with the temperature displayed.
Changing the domestic hot water
temperature
CAUTION
Function available depending on the model of control panel.
menu is displayed.
3. Operating instructions
EN
41