Using The Appliance As A Steam Cleaner; Using Steam And Suction Simultaneously - Lavorwash LAVOR Pro GV EGON VAC Bedienungsanleitung

Using the appliance as a steam cleaner

7.3
Please refer to the chapter "
boiler switch (E), the respective pilot lights (H) and (I) will come on. Water will start heating up and
steam will then be produced
the appliance.
The gauge (K) indicates the pressure inside the boiler:
the grey/silver area indicates the ideal pressure for use
When the pilot light (F) comes on, the appliance will be ready to function with steam. Now press the
lever (26) on the handgrip (23). The first amount of steam will come out with water condensation;
direct the jet to one side or onto a cloth.
The handgrip (23) has a safety lock (23) which prevents steam from accidentally escaping:
• left lock: the lever is free
• right lock: the lever is locked.
Note: To obtain the correct quantity of steam, wait 3-4 minutes
for the water to heat up.

Using steam and suction simultaneously

7.4
Please refer to the chapter "6.2 Starting up the boiler" before use.
To steam and vacuum simultaneously: it is possible to use the
above-mentioned steam-cleaning functions together.
When work is finished, release the steam lever (26) a few
moments prior to switching off the suction motor (button 27).
This will allow the suction ducts to recover the humidity.
Note: Whilst you are working, it is normal to occasionally hear
the pump as it pumps in the water. Be careful not to confuse
this noise with audible warning signal (beep) made when the
boiler water tank is empty.
EN
Starting up the boiler" before use. Press the main switch (D) and the
6.2
. Pre-select the amount of steam using the knob (J) located on
(picture 16)
.
(picture 17)
D E
picture 16
F G H I
picture 17
picture 18
9