Use; Assembly Instructions; Programming - Cuisinart DGB900BCE Hinweise

12 13 14 15

3. USE

A. ASSEMBLY INSTRUCTIONS
Before you use the machine for the first time, or when it has not
been used for some time, fill the water reservoir with cold water
to the maximum level (without coffee or filter), deactivate the
coffee grinder (push the 'Grind Off' button), put the carafe in
position and run a full cycle.
1. Inserting the water filter
water for 15 minutes.
allow the filter to drain completely.
Open the compartment, pull out the filter basket, insert the
filter, slide the filter basket into the bottom of the water
reservoir and close.
Programme
16 17 18
2. Rinsing the carafe
indicated.
3. Placing a coffee filter in the filter basket
CAUTION! The appliance will only operate if the bean hopper
and the lid to the filter compartment are properly shut. If the
bean hopper is removed at the beginning of or during the cycle,
the coffee maker will beep continuously until it is replaced then
turned off. If the lid is opened at the beginning of the cycle, the
19
coffee maker will beep continuously even after the lid is closed
again. The beep will only stop once OFF is pressed. If the lid is
opened during the cycle the coffee maker will beep 5 times and
stop. To restart the appliance, press the ON button.
B. PROGRAMMING
1. Setting the time
numbers start to flash.
numbers. When the numbers stop flashing, the time has
been set.
CAUTION! When you go past the number 12, the letters 'PM' will
appear to adjust the time from 12 noon to midnight. When 'PM'
is not shown, the time indicated corresponds to the AM hours,
from 12 midnight to 12 noon. Always make sure that the time
is set according the correct period so that the programming is
correct.
2. Programming the start time
indicator light will flash.
buttons as described for setting the time. When the
numbers stop flashing, the scheduled time is programmed.
CAUTION! You will not be able to program the start time while
the coffee machine is running.
11