Special Accessory Installation; Choice Of Location - Truma Mover Se R Gebrauchsanweisung, Einbauanweisung

5. Installation with Eriba Touring chassis
The Eriba Touring mounting set is needed for the
Eriba Touring chassis.

Special accessory installation

1. Spacer set 30 mm
For compensating the height differ-
ence for caravans / trailers with a
frame height of less than 170 mm
and up to 140 mm,
part no. 60030-95000.
2. Spacer set 60 mm
For compensating the height differ-
ence for caravans / trailers with a
frame height of less than 140 mm
and up to 110 mm,
part no. 60030-95100.
3. Low chassis kit
For compensating the height differ-
ence for caravans / trailers with a
frame height of less than 110 mm
and / or for bridging struts,
part no. 60010-64900.
In Germany, this installation kit
must be accepted by a vehicle expert.
4. Low chassis kit, short
For compensating the height differ-
ence for caravans / trailers with a
frame height of less than 110 mm,
part no. 60030-37600.
In Germany, this installation kit
must be accepted by a vehicle expert.
5. AL-KO Vario III / AV
Installation kit
For caravans with
AL-KO Vario III / AV Chassis
(frame thickness less
than 2,8 mm) mandatory,
part no. 60010-21500.
6. AL-KO Chassis M adapter kit
for chassis with axial displace-
ment with a permitted gross
weight of 1800 kg
Mounting set for compensating
for frame edges for caravans with
AL-KO Chassis M. Mounting set
is needed for mounting in front of
the axle,
part no. 60030-38600.
7. AL-KO Chassis M
adapter kit for chassis with
a continuous frame and a
permitted gross weight of
1900 kg to 2000 kg
Mounting set for compensating
Fig. 9 for frame edges for caravans
with AL-KO Chassis M. The
mounting set is needed for
mounting in front of the axle,
part no. 60031-02000
8. Mover® mounting set
for Eriba-Touring,
part no. 60030-09000.
Fig. 10
9. Eriba Troll Mounting Set
The Eriba Troll Mounting Set al-
lows the Mover® to be mounted
behind the axis on an Eriba Troll
caravan/trailer.
part no. 60031-03000
Installation is not possible in some cases because of
Fig. 11 attachments to the underbody. Contact your dealer if
necessary.
Detailed installation instructions are provided with the
relevant mounting set.
The Mover® SE R / TE R is not approved for in-
stallation on caravans / trailers with any other
chassis!
No holes may be drilled into or welding work performed on
the vehicle frame (except when using the low chassis kit* and
the Eriba-Touring mounting set). Under no circumstances re-
Fig. 12 move any suspension components from the chassis.
* In the case of the AL-KO Vario III / AV Chassis, never drill
into the vehicle frame even if the flat frame kit is used.

Choice of location

The Mover® should preferably be installed in front of the axle,
but can also be installed behind the axle under special circum-
stances (e.g. lack of space). Only the bolts that are provided
must be used to secure the Mover® (or the add-on parts
provided as special accessories).
Fig. 13
Fig. 14
Fig. 15
Fig. 16
Fig. 17
21