MaxPro PROFESSIONAL MPCD18HLi/2E Bedienungsanleitung Seite 11

T orque se htening power of your drill)（Fig.3）
When using your drill for various driving applica
power and torque in order to prevent the possibility of damaging screw heads, threads, work pieces, etc
In general, power and torque should correspond to the difficulty of the screw to be driven. If torque is too
high, the screws can be damaged or broken
Torque adjustment （Fig.3）
• 1 - 18 Tight the screw.
• Drill hole
Impact rotary
•
To Adjust Torque（Fig.3）
• Lo cate the arrow on the front of the drill housing.
• Iden fy the torque se
adjustment collar to the desired se
the arrow on the drill housing.
• To increase or decrease torque, rotate the torque adjustment collar. The lower the number, the lower the
torque se
Always check that the correct torque is selected by pr
The torque se required to drive screws will differ with different materials. Start with the torque se
on the number you think is appropriate and simply increase the torque adjustment collar to a higher
number if the screw head is not si
e-drive the screw back into the work piece un
with your work piece.
When spindle lock is selected ,the motor´s spindle is locked and so the chuck and screwdirver or drill bit
cannot turn.
Keyless Chuck
A keyless chuck is included on your drill to allow for easy installa
chuck is divided into two parts. The rear is called the collar and the front is the body.
To open and close the keyless chuck, grasp and hold the collar of the chuck with one hand and rotate the
chuck body with your other hand.
The arrows on the chuck indicate in which dir
RELEASE (unlock) the drill bit.
Warning! Do not hold the chuck body with one hand and use power of the drill t
chuck jaws. The chuck body could slip and your hand could come in contact with a rota
could cause an accident r
Changing the Dir
The dir rota
variable speed switch.
To select the forwar
The variable speed switch can be locked off by pushing the forward/reverse selector into the middle of both
the forward and rever
Do not change the dir
DRILL OPERATION
The Variable Speed Switch（Fig.5）
Turn the drill ON by depressing the variable speed switch
To turn the drill OFF release the variable speed switch
Speed Control（Fig.6）
The drill has a 2-speed gearbox, the speed selector(3) is located on the top of the drill. First gear has a
range of 0-400/min, second gear has a range of 0-1400/min. the speed can be varied from 0 to maximum in
switch. This way you can select the best possible speed for the job required
6
e
g, aligning the required number on the torque adjustment collar with
r, the higher the torque se
rsonal injury.
Rota
（Fig.4）
can be changed with the forward/release selector, this is located above the
forward/reverse selector hard right
rota
comes necessary to increase and decrease the
torque adjustment collar. • Rotate the torque
rap material prior to carrying out a job.
your work piece. Remove the screw a er adjus
correct torque adjustment leaves the screw head flush
to rotate the chuck body in order t
forward/reverse selector hard le
ke
GB
removal of bits/accessories. The
hten or loosen the
To select the reverse
hten) or
ry. This