Applying the floor covering and adjusting
the height
A pply the floor covering, leaving an expan-
sion joint of 1–5 mm to the device tank .
a nd Adjust the height of the top edge of
the service outlet, so that it is flush with the
top edge of the floor covering . To do so, un-
screw the four height adjustment supports
accordingly, using a slotted screwdriver .
F ill the expansion joint around the service
outlet using a suitable flexible material (e .g .
silicone) .
Disposal
– Packaging as household waste
– Service outlet as scrap metal
Comply with the local waste disposal regula-
tions .
EN
25