Herunterladen Inhalt Inhalt Diese Seite drucken

Concept KS3005 Bedienungsanleitung Seite 30

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 33
Assembly:
1. Draw two parallel lines 330 mm apart on the wall according to Fig. 3.
2. Mark and drill two holes corresponding with the diameter of the supplied dowels on the top line. The distance
between their centres is 410 mm.
3. Mark two holes with their centres 435 mm apart on the bottom line so that they are symmetrical with the top
holes. Drill the bottom holes with a drill of appropriate diameter according to the supplied dowels.
4. Insert the supplied dowels in the four holes.
5. Put the supplied screws in the top holes. Allow an approximate 8 mm clearance between the screw head and the wall
(Fig. 4).
6. Put suspension hooks on the screw heads and firmly tighten the screws (Fig. 5).
Fig. 4
7. Screw the spacers to the bottom section of the appliance (Fig. 6). Make sure the spacers are located on the same
side as the cut-outs for suspending the appliance.
Fig. 6
28
Fig. 3
Dowel
Screw
Screw
Suspension hook
Fig. 5
EN
KS3005

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis