Hammerbacher XMST Serie Betriebsanleitung Seite 49

Please observe the safety notes!
Reset obligations prior to initial operation:
- The table must be in the correct position before initial operation.
- The power must be connected before initial operation.
- A reference drive (Reset) must be carried out on the table before initial operation.
For this proceed as follows:
Press the 'down' button on the controls and hold it down. After
10 seconds the table will move to the lowest position and a small 'click' can be heard.
If the button is released before the process is complete then the RESET process is interrupted and must
be started again.
drive.
Please retain these instructions!
XMST 49