Kalorik TKG IKP 2 Gebrauchsanleitung Seite 11

Fax +32 2 359 95 50

Timer
 When you have selected a power setting, you can set a cooking time.
 To do so, press the « MENU » key once. The indicator lamp on the left of the watch
lights up and « _ _ _ » flashes on the display for 5 seconds.
 During this time, turn the knob to + or – to choose a cooking time (in minutes). You can
select a cooking time up to 180 minutes. The number of minutes will appear on the control
panel.
 When you stop turning the knob, the last settings will be memorized and the control panel
will show the power and the remaining time alternately. To change the power, turn the
knob when the control panel shows the power.
 To change the cooking time when the appliance is in use, press the « menu » key. The
remaining cooking time will flash for 5 seconds and you will be able to change it by
turning the knob to + or -.
CAUTION : IF YOU DO NOT SET A COOKING TIME, THE APPLIANCE WILL FUNCTION WITHOUT
INTERRUPTION.
Temperature mode
 According to your needs, you can choose the power mode or the temperature mode.
 To switch to temperature mode, press the « menu » key until the red indicator lamp on the
left of symbol «
 The default temperature setting is « 140» °C but you can adjust the temperature (between
60 and 220°C) by turning the knob to the left (-) for a lower temperature or to the right (+)
for a higher temperature. Once the temperature has been set, it ceases to flash on the
control panel and the temperature and the remaining cooking time will be shown
alternately.
 To change the temperature when the appliance is in use, you just need to turn the knob
to + or -.
 When you want to switch off the cooking plate, press the ON/OFF switch again.
End of cooking
 When the set time is finished, 5 beeps will sound and the appliance will stop heating and
will switch off.
 If you remove the receptacle from the cooking plate before the set time is finished, « E 1 »
will appear on the display and beeps will sound. In that case, put the receptacle back on
the cooking plate to continue cooking or press the ON/OFF switch to switch off the plate.
 « - » flashes on the control panel and the fan of the cooking plate will keep functioning for
a while to cool the appliance. Do not unplug the appliance as long as the cooling is not
finished.
Error message : E6
When a too high temperature is detected, « E6 » will appear on the control panel. The cooking
process will therefore be interrupted to decrease the temperature. Wait about 1 minute and
reprogramme the appliance as before. If the message stays, switch off the appliance and let it
cool down.
FEATURES OF THIS PRODUCT
A. Energetic efficiency
The plate starts heating as soon as you have put an adequate pot or pan on the plate and
stops heating as soon as you remove it. The thermal efficiency reaches 95%.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
°C
» lights up.
Assembly page 11/48
11
TKG IKP 2 - 090615