Kalorik TKG IKP 2 Gebrauchsanleitung Seite 10

Fax +32 2 359 95 50

Do not place the induction hotplate next to devices or objects which react sensitively to

magnetic fields (e.g. radios, TVs, cassette recorders, etc.).
Do not place any magnetic objects like credit cards, cassettes etc. on the glass surface

while the device is in operation.
Immediately unplug the appliance if a crack appears and make sure it is controlled

by a qualified competent electrician(*).
Your appliance must never be switched on through an external timer or any kind of

separate remote control system.
Competent qualified electrician: after sales department of the producer or importer or any
(*)
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this electrician.
SUITABLE AND UNSUITABLE COOKWARE FOR THE INDUCTION COOKING PLATE
Suitable Cookware
 Pots and pans with a magnetic bottom, such as stainless steel pots with an iron bottom,
cast iron, enamelled pans
 Flat-bottomed pans and pots with a diameter of 12 to 25 cm with a magnetic bottom
 Maximum weight of pot and content: 6 kg
Unsuitable Cookware
 Pots/pans with a diameter of less than 8 cm
 Ceramic pots, heat-proof glass
 Copper pots and pans, aluminium pots and pans
 Containers with a curved bottom
USE
 Make sure the tension indicated on the appliance's rating label corresponds to the tension
of your mains.
 Put the appliance on a stable, dry and heat-resistant surface near a power outlet.
 Put the plug in an earthed power socket. « - » appears on the control panel, indicating
that the appliance is connected to the mains.
 Always place your cooking receptacle well in the middle of the cooking plate before
switching it on. If you don't put a receptacle on the cooking plate or if you use a
receptacle that is not suitable, the appliance will not heat and « E 1 » will appear on the
display.
 Use only pans and pots especially conceived for induction cooking with a flat bottom of
12 to 25 cm diameter.
Power mode
 When you press the ON/OFF switch, the control panel lights up and the power mode is the
default setting.
 The default power setting is « P-6 », but you can adjust the power (from P-1 to P-10) by
turning the turning knob to the left (-) for a lower power or to the right (+) for a higher
power. Once the power is set, it ceases to flash on the display and the control panel will
show the power and the remaining cooking time alternately.
 To change the power when the appliance is in use, you just need to turn the turning knob
to + or -.
 When you want to switch off the cooking plate, press the ON/OFF switch again.
P-1 = 300W, P-2 = 400W, P-3 = 600W, P-4 = 800W, P-5 = 1000W, P-6 = 1200W, P-7 = 1400W, P-8 =
1600, P-9= 1800W, P-10 = 2000W
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
10
Assembly page 10/48
TKG IKP 2 - 090615