Operation Guide - Razorri Premio Rckm1Ka Bedienungsanleitung

Before using for the first time
Prior to initial use, clean it by going through several boiling cycles, using clean water with each
cycle and filling the kettle (4) to its upper marking.
Operation
Place the cordless base (7) on a firm and level surface.
Pour the desired amount of clean water into the kettle (4), Do not touch any part of the kettle
except the handle.When the appliance is in use, and ensure that the cover (2) is properly closed,
The amount of water can be measured by the level mark on the inside of the kettle , Always pay
attention to the minimum and maximum levels and ensure that the cover (2) is properly and
firmly closed .
Position the kettle in such a way on the sub base (5) that the underside of the kettle fits
precisely into the contact on the base.
Insert the plug into a wall socket.
Put the on/off switch (6) to its '1' position to start the heating process , The indicator lamp will
light up .
As soon as the water reaches boiling point, the on/off switch (6) return automatically to the
"0"position, the indicator lamp will go out. The water kettle can also be switched off manually
by putting the on/off switch to the "0"position.
The hot water may now be poured safely through the spout into another container, safety cut –
out.
This kettle is equipped with a safety cut –out to protect the appliance from damage in case of
inappropriate use, should the appliance be accidentally operated without water or if all the
water has evaporated the safety cut out will automatically switch off the heating element.
In such a case remove the plug from the wall socket immediately and refill the kettle only after
an adequate cooling down period, about 15—20seconds.
Decalcifying
Should the appliance switch off before reaching boiling point this is a sign that decalcifying is
necessary.
Any regular descaling agent may be used, provided the relevant instructions are observed, Do
not fill the kettle to the upper mark to avoid spillage if the descaling agent causes the water to
foam .
To clean the kettle thoroughly of any decalcification residues let it go through several boiling
cycles using clean water with each cycle , Rinse the kettle with clean water afterwards.

Operation Guide

05