Installing The Wall Bracket; Inserting / Replacing Batteries; Operating The Light By Switch; Using The Remote Control - LIVARNOLUX DE-LED-00867 Montage-, Bedienungs- Und Sicherheitshinweise

light now match the position of the ceiling
5
screws.
Carefully push the LED ceiling light
the ceiling until you feel resistance, then turn the
LED ceiling light
5
arrow decal) until you hear a „click". The LED
ceiling light is locked into place and instal-
5
lation is complete.
Verify again, the LED ceiling light
into all three ceiling screws
peat this process.
You may now remove the decals
LED ceiling light
5
Replace the fuse or switch on the circuit breaker
in the fuse box (I position).
Your LED ceiling light
5
ready for use.

Installing the wall bracket

Install the wall bracket for the remote control
using the screws
27
shown in Figure E.

Inserting / replacing batteries

Note: The remote control requires two batteries type
AAA / LR03 (included).
Slide the battery case cover (reverse) down by
approx. 1 cm to open and then lift off the cover.
Insert two batteries of the included type
AAA / LR03 in the battery compartment. Please
note the correct polarity!
Slide back the cover to close the battery com-
partment.
Your remote control is ready to use.

Operating the light by switch

The LED ceiling light
and off using the wall switch. Here the bright-
ness will always be 100 %. All other functions
are solely controlled via remote control.
against
5
to the right (direction see
is locked
5
. Otherwise re-
9
from the
1
and ceiling.
with Bluetooth speaker is
or adhesive pads as
26
may be switched on
5

Using the remote control

ATTENTION! The functions of the remote control
can only be used after switching the LED ceiling
light on with the wall switch.
5

Switching the light on / off

1. Switching the light on
Press the "
LED ceiling light
tion of the signal.
2. Switching the light off
Press the "
the LED ceiling light
reception of the signal.

Dimming the light

1. Increasing brightness
25
Press the "
the brightness. A beep will sound when reach-
ing the maximum brightness. Briefly pressing this
button will gradually increase the brightness as
pressed. Holding the "
will automatically increase the brightness to the
maximum.
2. Reducing the brightness
Press the "
the brightness. A beep will sound when reaching
the minimum brightness. Pressing it briefly will
gradually decrease the brightness as pressed.
Holding the "
matically decrease the brightness to the minimum.

30 minute timer

1. Activating the timer
Press the "
ing light off automatically. A double beep
5
confirms reception of the signal.
The light and the Bluetooth function (music) will
automatically switch off after approx. 30 minutes.
Initial use
" button (lighting) , to switch the
13
on. A beep confirms recep-
5
" button (lighting) , to switch
14
off. A beep confirms
5
" button Dimmer + , to increase
15
" button Dimmer +
" button Dimmer – , to reduce
16
" button Dimmer –
16
" button to switch the LED ceil-
17
15
will auto-
GB 9