Preparation; Required Tools And Material; Prior To Installation; Initial Use - LIVARNOLUX DE-LED-00867 Montage-, Bedienungs- Und Sicherheitshinweise

Safety / Preparation / Prior to installation / Initial use
Avoid battery fluid coming into contact with the
skin, eyes and mucous membranes. In the event
of contact, immediately rinse the affected area
with plenty of clear water and seek immediate
medical attention.

Preparation

Required tools and material

The tools and materials specified are not included.
This information and these values are non-binding
and are only provided as a reference. The nature
of the material is determined by the individual local
conditions.
– Pencil / marking tool
– Voltage tester
– Screwdriver
– Electric drill
– Drill bit (approx. Ø 6 mm)
– Hammer
– Side cutter
– Ladder

Prior to installation

Important: The electrical connection must be per-
formed by a trained electrician or a person instructed
in electrical installation. This person must be familiar
with the properties of the light and connection reg-
ulations.
Do not remove the decals on the light (marking A,
B, C, etc.) used as an installation guide, after com-
pleting installation.
Familiarise yourself with all the instructions and
illustrations in this manual, as well as with the
light itself, before installing it.
Prior to installation, verify the circuit to which the
light will be connected is not energised. To do so,
remove the fuse or switch off the circuit breaker
in the fuse box (0 position).
Use the voltage tester to verify the de-ener-
gised status.
8 GB

Initial use

Mounting / installing the light

(see Fig. A–D)
ATTENTION! Do not remove the decals on the
light (marking A, B, C, etc.) used as an installa-
5
tion guide, after completing installation.
The LED ceiling light
sealed system, thus fully assembled. Do not
open the LED ceiling light
Prior to installation, verify the circuit to which
the light will be connected is not energised. To
do so, remove the fuse or switch off the circuit
breaker in the fuse box (0 position).
Centre the unprinted side of the mounting tem-
plate over the mains connection cable
6
and determine the position of your LED ceiling
light on the ceiling. Be sure the logo for the
5
terminal block is located near the exit for the
7
mains cable . The mains cable
2
ideally be at least 15 cm long.
Mark the three bores (1, 2, 3)
mounting template
decals (A, B, C)
1
with the recess on the side edge (A, B, C) of the
mounting template
the mounting template
Drill the holes (1, 2, 3). Be sure not to damage
the supply line.
Insert the wall plugs
sary, use a hammer.
Screw the included screws
plugs so they still protrude approx. 8 mm
8
from the ceiling.
Insert the three building wires in the terminal
block of the LED ceiling light
10
by the colours and screw down.
Note: Be sure to connect the individual wires
of the mains cable (external)
live wire, black or brown = symbol L,
neutral wire, blue = symbol N,
earth wire, green-yellow = symbol
After wiring to the building wiring, align the LED
ceiling light as follows: the decals (A, B, C)
5
on the LED ceiling light
12
decals (A, B, C)
1
screw holes on the back of the LED ceiling
11
is constructed as a
5
for installation.
5
2
should
2
using the
3
and apply the included
6
to the ceiling congruent
. You may now remove
4
.
6
into the bores. If neces-
8
into the wall
9
as indicated
5
correctly:
2
must match the
5
on the ceiling. The screw