Safety; Safety Instructions; Safe Working; Safety Instructions For Batteries - LIVARNOLUX DE-LED-00867 Montage-, Bedienungs- Und Sicherheitshinweise

Bluetooth range:
Control method
Remote control:
Remote control range:

Safety

Safety instructions

Damage due to failure to comply with these instruc-
tions for use will void the warranty! We assume no
liability for consequential damages! We assume no
liability for property damage or personal injury due
to improper handling or failure to comply with the
safety instructions! Do not leave the lamp or packag-
ing material lying unattended. Plastic film or bags,
plastic parts, etc. can be dangerous for children to
play with.
Avoid the risk of fatal injury
from electric shock
Have the electrical installation performed by
an electrician or a person trained in electrical
installation.
Always check the mains supply for damage be-
fore connecting it to the mains. Never use the
light if it shows any signs of damage.
CAUTION! A damaged mains cable poses a
danger to life due to electric shock. In the event
of damage, repairs or other problems with the
light please contact the service centre or an
electrician.
Prior to installation, remove the fuse or switch off
the circuit breaker (0 setting) in the fuse box.
Prior to installation, verify the mains voltage on
site corresponds with the operating voltage re-
quired for the light (220–240 V∼, 50 / 60 Hz).
Never allow the light to come into contact with
water or other liquids.
Never open the housing of the light or insert
any objects into it. This will pose a risk of fatal
injury from electric shock.
approx. 10 m
infrared
< 8 m
Introduction / Safety
The LED module is not replaceable. If the LED
module fails at the end of its life, the entire light
must be replaced.
Do not install the light on a wet or conductive
surface!
Prevent fire and risks
of injury
Do not leave the light or packaging lie about
carelessly. Plastic film or bags, plastic parts,
etc. are dangerous for children to play with.
Do not cover the lamp with objects. Excessive
heat can result in fire.

Safe working

Mount the light so it is protected from moisture
and dirt.
Carefully prepare for assembly and allow your-
self adequate time. First organise all parts or
materials so they are easy to reach.
Always be attentive! Always pay attention to
what you are doing and proceed with caution
at all times.
Never assemble the lamp whilst unfocused or
feeling unwell.

Safety Instructions for batteries

Never expose batteries to excessive heat such
as sun, fire, etc. The batteries may explode!
Never recharge non-rechargeable batteries.
Explosion hazard!
Keep batteries away from children, do not
short-circuit or take apart.
Replace all batteries in a set. Only use the same
types of batteries together, never mix types or
used and new batteries.
Clean battery contacts and the contacts inside
the device before inserting the batteries.
Be sure to insert the batteries correctly, i.e. note
the polarity (+ and –).
Remove drained batteries immediately.
Increased risk of leaks!
GB 7