Werbung
4
Ethernet Controller Keypad
Item
Power over Ethernet Injector (Noth America)
Power over Ethernet Injector (Europe)
B
Do not attempt to install or use until you read
and understand the installation instructions and safety
labels.
Assurez-vous d'avoir lu et compris les instructions d'installation et les
autocollants de sécurité avant l'installation ou l'utilisation.
Installieren oder verwenden Sie einen Beleuchtungskörper erst,
nachdem Sie die Installationsanweisungen und Sicherheitsetiketten
gelesen haben
No intente instalar ni utilizar hasta haber leído y comprendido las
instrucciones de instalación y las etiquetas de seguridad.
Non installare o utilizzare se non sono state lette e comprese le
istruzioni per l'installazione e le etichette di sicurezza.
Voer geen poging uit tot installeren of gebruik totdat u de installatie-
instructies en veiligheidslabels hebt gelezen en begrepen.
設置手順と安全ラベルの内容を読み、 理解してから設置または使
用を始めてください。
请先阅读并理解安装说明和安全标签，再进行安装或使用。
Philips Color Kinetics
3 Burlington Woods Drive
Burlington, Massachusetts 01803 USA
Tel 888.385.5742
Tel 617.423.9999
Fax 617.423.9998
www.philipscolorkinetics.com
Installation Instructions
B
Do not use if the product housing or power cables
are damaged.
N'utilisez pas l'appareil si le boîtier ou des câbles d'alimentation sont
endommagés
Nicht verwenden, wenn das Produktgehäuse oder die Netzkabel
beschädigt sind.
No utilice el producto si la carcasa o los cables de alimentación están
dañados.
Non utilizzare se l'alloggiamento del prodotto o i cavi di
alimentazione sono danneggiati.
Niet gebruiken indien de behuizing of stroomkabels zijn beschadigd.
製品のハウジング、 または電源ケーブルが損傷している場合は、 使
用しないでください。
如果产品的灯壳或电缆受损，切勿使用。
B
Do not modify or alter the product. Doing so will
void the warranty.
Ne transformez pas et ne modifiez pas le produit. Toute modification
annule la garantie.
Nehmen Sie keine Veränderungen an dem Produkt vor.
Nichtbeachtung entwertet die Garantie.
No modifique ni altere el producto. Si lo hace, se anulará la garantía.
Non modificare né alterare il prodotto, in caso contrario la garanzia
verrà invalidata.
Wijzig of verander niets aan het product. Hierdoor zal de garantie
vervallen.
製品を改ざんしたり、 変造したり しないでください。 改ざんや変造
を行うと、 保証が無効になります。
切勿修改或更改产品。否则将使质保失效。
Item Number
109-000029-00
109-000029-01
Copyright © 2008 – 2011 Philips Solid-State Lighting Solutions, Inc. All rights reserved.
Chromacore, Chromasic, CK, the CK logo, Color Kinetics, the Color Kinetics logo, ColorBlast,
ColorBlaze, ColorBurst, ColorGraze, ColorPlay, ColorReach, DIMand, EssentialWhite, eW, iColor,
iColor Cove, IntelliWhite, iW, iPlayer, Light Without Limits, Optibin, and Powercore are either
registered trademarks or trademarks of Philips Solid-State Lighting Solutions, Inc. in the United
States and/or other countries. All other brand or product names are trademarks or registered
trademarks of their respective owners. Specifications subject to change without notice.
Part Number
910503700383
910503700384
C
Equipment to be used in a Network
Environment 0 per IEC TR 62101. The Multi-
Synchronizer Pro is to be connected only to PoE
networks without routing to the outside plant.
C
A power supply powering the Ethernet
Controller Keypad will be a 48V dc minimum 1A
output, which is a Limited Power Source (LPS)
output.
C
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two condi-
tions: (1) this device may not cause harmful interfer-
ence, and (2) this device must accept any interference
received, including interference that may cause unde-
sired operation.
These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
• Consult the dealer
C
This Class B digital apparatus complies with
Canadian ICES-003. Cet appareil numerique de la
classe B est conforme a la norme NMB-003 du Canada.
Werbung
