Herunterladen Diese Seite drucken
Philips ActiLume DALI gen2 Montageanleitung
Philips ActiLume DALI gen2 Montageanleitung

Philips ActiLume DALI gen2 Montageanleitung

Werbung

ActiLume DALI gen2
R
c e
s e
e s
d
DALI 1
(window)
DALI 2
(corridor)
Max. 11x Slaves (S) per Master (M)
4422 004 21633
Data subject to change without notice
Printed in EU
www.philips.com/lighting
All rights reserved
2018 Signify Holding.
ActiLume
M
S
M
S
S
S
S
scene
Red-Movement detected
Yellow-No movement detected
S
r u
a f
e c
/
S
s u
p
e
n
d
e
d
ActiLume
M
M
ActiLume
M
Max. 11x Slaves (S) per Master (M)
1
2
S
S
S
S

Werbung

loading

Inhaltszusammenfassung für Philips ActiLume DALI gen2

  • Seite 1 ActiLume DALI gen2 Red-Movement detected Yellow-No movement detected ActiLume ActiLume DALI 1 (window) ActiLume DALI 2 scene (corridor) Max. 11x Slaves (S) per Master (M) Max. 11x Slaves (S) per Master (M) 4422 004 21633 Data subject to change without notice Printed in EU www.philips.com/lighting...
  • Seite 2 Light level calibration IRT9090 SAVE DOWN Max. 3 m 500lx Movement detection area high sense* low sense* height (m x m) (m x m) 3.50 5.60 x 5.60 8.40 x 7.00 heigh 3.25 5.20 x 5.20 7.80 x 6.50 3.00 4.80 x 4.80 7.20 x 6.00 2.75...
  • Seite 3 Only for recessed daylight DALI 1 ActiLume (window) (+30%) DALI 2 (corridor) Mode selection with Service Button Mode 1 Mode 2 100% Mode 2 Mode 1 100% < 1 sec. Mode 1= Default mode Mode 1= Reglage usine Mode 1= Standardeinstellung Mode 1= Standaardinstelling Mode 1= Modo por defecto Mode selection with IRT9090...
  • Seite 4 15 min. 15 min. 120 min. Mode 1 & 2 15 min.
  • Seite 5 Power up (Light on after 30 sec.) Default mode Reglage usine Standardeinstellung Standaardinstelling Modo por defecto 30 sec. 230V 230V 230V Change Power up (Light on immediately - 0 sec.) Lights must be switched on! IRT9090 I/II 0 sec. 10% A 20% B 30% C 1.
  • Seite 6 Ceiling mount movement detector, which can be used to extend the movement coverage area of an ActiLume system. LRH8100 Détecteur de mouvement en plafond utilise pour étendre la zone de detection du systeme Actilume. Anwesenheitssensor zur Erweiterung des Erfassungsbereichs, Anschluss an die DALI-Steuerleitung, Deckeneinbau (LRH8100: Deckenanbaugehäuse).