Werbung
Verfügbare Sprachen
Verfügbare Sprachen
BINDING
Connecting transmitter and receiver:
The vehicle is ready to drive when it leaves the factory. In normal
circumstances, therefore, the binding function is not necessary!
1
Press and hold down the Binding button on
the receiver and then switch on the receiver.
The LED on the receiver then flashes rapidly!
HOW TO CONTROL YOUR MODEL
• Raise the tyres off the ground
• Turn the steering wheel to the right and left as far as it will go. The
wheels are to follow the steering direction.
• If the wheels operate in the opposite direction, operate the servo
Reverse switch (ST in position REV).
• To regulate the driving speed, actuate the throttle/brake
- backwards (forward driving, accelerating) or
- forwards (braking, reversing)
Left
Right
GB // Reflex Wheel S
The binding function should only be used if there are any connec-
tion problems between the vehicle and the transmitter or if the
transmitter/receiver is replaced.
2
Press and hold down the Binding button
on the transmitter and then switch on the
transmitter.
Left
3
LED
The binding process is completed when
the LED on the receiver is permanently
illuminated.
Neu
tral
driving forward,
to give speed
Right
braking, reverse
movement
Werbung
