Comsafe MONACO Bedienungsanleitung Seite 9

01--33 MONACO Mlock Instr 17.3.2010:1 – 8
... you hear a long beep after your combination last digit and the lock does not open?
You are entering a not valid combination. Repeat the operation making attention you are
entering the correct code.
... light signal flashes every 10 seconds, and, when you push a button you hear a long beep?
You entered 4 times a wrong combination and the lock is in time penalty. Wait 5 minutes
and try again. Two more consecutive invalid codes will restart additional 5 minutes penalty
period.
... you do not hear any beep when you push a button?
Replace the battery. If the problem is not solved, call your service centre.
... you can open but you hear a long sequence of beeps after your combination last digit?
Immediately replace the battery. (use only 9V Duracell Procell Alkaline or Energizer batteries)
Change code: (with safe door open, see fig. C)
Press and hold Key [0] until double signal. The light remains on during the following actions.
• Enter old code (double signal)
• Enter new code (double signal) and repeat new code (double signal)
In case of entry errors (long signal), the old code remains valid.
Press and hold Key [3] until double signal. The light remains on during the following action.
• Enter main code.
The secondary code is deleted.
1.1 For Entry Units Monaco the battery compartment is located at the bottom of the entry unit.
To replace the batteries, do as follows:
1.2 Press the slide, which is placed on the underneath of the entry unit, to the right side.
1.3 Exchange the old battery with a new one.
1.4 Put the new battery back into the entry unit and close the slide.
1.5 The programmed codes remain unchanged when changing the batteries!
What if...
Delete the secondary code: (see fig. D)
Battery change
Mobil-5.06 print 18.03.2010
MONACO Electronic Safe
14:48 Uhr Seite
9