Plantui 6 Smart Garden Bedienungsanleitung Seite 7

7. Holiday Pause
You can use Holiday Pause to make your plants use less water and grow slower when you are away.
Plantui 6: Hold your hand on top of the Light Unit (13) for 10 sec until the lights turn purple.
Plantui 3e: Press the button in the Light Unit (13), for 10 sec until the lights turn purple.
Add nutrients and water if necessary. NOTE: The water level should not exceed the limit line inside
the bowl. Holiday Pause does not work without Height Blocks. Return the device to the normal mode
by sweeping your hand on top of the Light Unit (Plantui 6) or pressing the button once (Plantui 3e).
8. Harvesting
You can start using the plants when they are big enough. Check out the plant specific growing
instructions and harvest times on our web site www.plantui.com.
9. Removing deposits / Descaling
Tap water may form deposits in the pump and on the plastic parts.
Plantui 6: Add 1 tablespoon (15 ml) of citric acid with 3 liters of warm water (max 55 °C) in the water
bowl (16) of an empty Smart Garden. Hold your hand on the top of the Light Unit (13) for 15 secs until
the lights turn blue.
Plantui 3e: Add 1 teaspoon (5 ml) of citric acid with 1 liter of warm water (max 55 °C) in the water
bowl (16) of an empty Smart Garden. Press the button in the Light Unit (13) for 15 sec until the lights
turn green.
The pump will operate for 2,5 min. (If necessary, leave it to soak for a few hours and restart the
pump.) Then wash the parts in the dishwasher (max 55 °C, see part 10). Citric acid can be bought on
our web site www.plantui.com.
10. Washing the parts
Wash the bowl (16), the plant tray (15b) and the water tray (15c) after each crop. Wash the grey pump
by hand. NOTE: max. +55 °C. Do not wash the electrical parts (13, 14, 15a)!
11. Reassemble parts
11a. Assemble watering pieces together, by aligning the water holes with each other.
11b. Make sure the pump is locked.
12. Get new Plant Capsules
Visit our web site www.plantui.com for new and exciting plant varieties and flavours.
Rebooting the Light Unit
If any problems would occur with the Light Unit (13), reboot it by unplugging the device for
10 minutes. Then plug in the device and reset the sleep timer (see part 4). If this doesn't help,
contact us: help@plantui.com
www.plantui.com
NOTE: Do not place the Smart Garden on a tilted surface, in direct sunlight,
or outside.
If temperature is too high, the light will turn red.
English
3