Maintenance - Plantui 6 Smart Garden Bedienungsanleitung

English
Setting up
Check our Youtube channel @plantuicom for instruction videos.
Before setting up the device:
Pull off the Light Unit (13) from the Watering Unit (15). Lift off the Watering Unit (15) from the water
bowl (16).
1. Add water & nutrients
Plantui 6: 1a. Add 3 liters of water with 3 spoonfuls of nutrients to the water bowl (16).
Plantui 3e: 1a. Add 1 liter of water with 1 spoonful of nutrients to the water bowl (16).
The spoon is packed with the power unit inside the bowl. The nutrients are in the Plant Capsule
package. Do not exceed the water limit line! 1b. Place the Watering Unit (15) to the water bowl (16).
2. Place plant capsules
2a. Remove the centers of the labels. Take care that the seeds don't fall out from the hole. 2b. Place
the capsules to all empty holes. NOTE: Do not leave any holes empty, except the one that is only
for adding water. Push capsules firmly downwards. We recommend to grow plants with the same
growing time together. You can see the growth timelines on each Plant Capsule package.
3. Plug in the device
3a. Plug in the device. 3b. Put on the Light Unit (13) without a Height Block (14). Pink lights turn on, the
germination phase has begun. You can hear the first irrigation start. It's time to grow!

Maintenance

4. Sleeptimer
Plantui Smart Gardens sleep for 8 hours daily. The device will go automatically to sleep after 16 hours
from turning it on. The timer can be readjusted, if necessary.
Plantui 6: Set the sleep timer by holding your hand on top of the Light Unit (13) for 3 sec - lights will
blink 2 times and then turn off.
Plantui 3e: Set the sleep timer by pressing the button in the Light Unit (13), for 3 sec - lights will blink
2 times and then turn off.
The device will wake up after 8 hours and keep this rhythm if you don't change it.
5. Height Blocks
Add the first Height Block (14) when the first leaves appear. Add the 2nd Height Block before the
leaves touch the Light Unit (13).
6. Water & nutrients
If the pump starts to be noisy, the water level is low. You can check the water level by lifting up the
Watering Unit (15). Add 1 spoonful of nutrients to 1 liter of water and pour the solution into the water
hole. When water has run out completely, Plantui flashes blue (Plantui 6) or purple (Plantui 3e) lights.
NOTE: The water level should not exceed the limit line inside the bowl.
2 www.plantui.com