Removing And Replacing Parts - NAMCO NINJA ASSAULT DX Bedienungsanleitung

NOTES ON INSTALLATION
1m60cm or more
Play Zone
Pathway
MOVING THE MACHINE

REMOVING AND REPLACING PARTS

Adjustments or maintenance on this equipment should be carried out by suitably qualified
personnel only.
Do not make any alteration to this equipment without prior approval. Doing so could cause
unforeseeable danger.
Only parts specified by Namco Europe Ltd. should be used when replacing parts. (Including
screws)
Ensure that the power to the equipment is turned OFF before commencing any maintenance work.
(Trouble shooting, repairs etc.)
If performing work not described in this manual, contact your distributor for instructions, as no
responsibility will be accepted for damage or injury.
Parts of the Power Supply and Monitor remain hot and carry high voltage even after switching OFF
and could cause burns or electric shock. Take care not to touch these parts accidentally.
Make sure that the equipment is switched OFF before connecting or disconnecting any plugs or
connectors.
When moving the mains connector from the equipment, or the mains plug from the wall outlet,
always grasp the plug and not the cable.
Page 5