Specifications - Maktec MT361 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Stopper pole
1-2. Screw
2-1. Lock lever
2-2. Screw
3-1. Depth pointer
3-2. Screw
3-3. Stopper pole
3-4. Adjusting hex bolt

SPECIFICATIONS

Collet chuck capacity
Plunge capacity
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for flush trimming and profiling of
wood, plastic and similar materials.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : cutting grooves in MDF
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
Explanation of general view
3-5. Stopper block
4-1. Depth pointer
4-2. Screw
4-3. Stopper pole
4-4. Adjusting hex bolt
4-5. Stopper block
5-1. Lock lever
5-2. Screw
Model
-1
)
Overall height
Net weight
Safety class
) : 91 dB(A)
pA
) : 102 dB(A)
WA
2
) : 7.5 m/s
h
2
ENE010-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
ENF002-2
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
ENG905-1
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
ENG900-1
Designation of Machine:
Router
Model No./ Type: MT361
are of series production and
Conforms to the following European Directives:
2006/42/EC
And are manufactured in accordance with the following
ENG901-1
standards or standardised documents:
EN60745
4
6-1. Switch trigger
8-1. Feed direction
8-2. Bit revolving direction
8-3. Workpiece
8-4. Straight guide
10-1. Guide bar
10-2. Clamp screw
10-3. Straight guide
MT361
6 mm, 1/4" and/or 8 mm
0 - 35 mm
27,000
218 mm
2.7 kg
/II
Corporation as the
ENH101-15
responsible