Function Keys - Team Electronic HAM MobileCom 1011 Bedienungsanleitung

HAM_MobileCom-1011_man2_newDim2:Layout 1 7/17/2014 10:24 AM Seite 23

FUNCTION KEYS

[MEM]
MEMORY CHANNELS M1-M6:
To enter or quit the memory channel mode, press the key【MEM】(1). The letter M (21) to
the right of the frequency or the memory channel number indicates the active status of the
memory channel mode.
In channel mode the display reads ME--M(1-6). In frequency mode, the frequency of the se-
lected memory channel is displayed. Use the key【FRQ】(4) to switch between the channel
mode and the frequency mode. The selected frequency band (A-I) is shown on the top of the
LCD (13).
save a memory channel:
To save a channel as a memory channel, exit memory channel mode first.
Then, select the frequency and hold the key【MEM】until the memory channel mode is acti-
vated. The letter M and ME--M(1-6), with M(1-6) blinking, will appear.
Now, select the memory channel number where the frequency should be saved and hold the
key【MEM】until M(1-6) stops blinking.
[MODE]
To switch between the operating modes FM-AM-USB-LSB, press the control【MODE】(2).
The actual operating mode is shown in the upper left LCD (5).
[BAND]
To switch between the frequency bands A-B-C-D-E-F-G-H-I-J, press the control【BAND】(3).
The actual frequency band is shown in the upper left LCD (13).
[FRQ]
Use the control【FRQ】(4) to switch between frequency and channel mode.
[MENU]
All functions and settings of the HAM MobileCom 1011 are organized in three different
menus.
The menus channel settings (PD, HICUT, NB, ECHO, +10kHz, ROGER, BUSY, SCAN) and
general settings (BEEP, INDIC, MIC, NOG, TOT, TSR, TDC, SCAN, FIN, COLOR, RESET)
are activated with the control [MENU] (5).
To open the menu channel settings, press the key【MENU】(5) shortly. The symbol F (1)
appears in the upper left corner of the LCD. Press the channel selector [PUSH] (14) to open
the menu.
To open the menu general settings, press the key【MENU】(5) approximately 2 seconds.
Once the menu is activated, use the rotary channel selector (14) to select a function.
To edit the setting for the selected function, press the channel selector [PUSH] (14).
Make your selection by turning the rotary channel selector and press it to confirm your selection.
To exit the menu press any key.
[SCAN]
channel scanning
1. Start channel scanning by pressing the key【SCAN】(6). The symbol SC (4), located in
the lower left corner, starts blinking.
2. Change the direction of the scanning (Up / Down) by turning the rotary channel selector.
3. To stop the channel scanning press the key【SCAN】(6) again.
23