Install The Hardware - Axis Q1910 Installationsanleitung

Page 8

Install the hardware

For outdoor use, please install AXIS Q1910-E, or see www.axis.com for more information on
outdoor housing and other accessories
Install AXIS Q1910
The instructions below describe the installation of AXIS Q1910.
1. Attach the metal stand to the camera and make sure that the screws and plugs are appropriate
for the material (e.g. wood, metal, sheet rock, stone).
2. Connect the cables, see
Install AXIS Q1910-E
The instructions below describe the installation of AXIS Q1910-E.
Prepare the network cable
If a cable other than the provided cable is used, you need to prepare a network cable with a gasket.
Gently force the cable through the gasket provided and attach a network connector. It may be
necessary to pierce a hole in the gasket with the supplied screwdriver.
Notes:
• Do not force the network connector into the gasket.
• Do not pierce the gasket with a knife or other sharp object.
Install the wall bracket
1. Use the supplied drill template to prepare a wall, ceiling, or pole for installation of the wall
bracket.
2. Route the network cable through the wall bracket, the rubber gasket should be on the bracket
adapter end of the wall bracket, see illustration on page 7.
3. Install the wall bracket on a wall, ceiling, or pole and make sure that the screws and plugs are
appropriate for the material (e.g. wood, metal, sheet rock, stone).
.
Connect the cables,
AXIS Q1910/Q1910-E Installation Guide
on page 9.