Program Playback; Maintenance - Bigben Interactive MCD06 Bedienungsanleitung

PROGRAM PLAYBACK

FOR NORMAL COMPACT DISC PLAYBACK
Programmed playback enables tracks on a disc to be played in the desired order.
Up to 20 tracks can be programmed.
1. Press the " PROGRAM / CLOCK-ADJ. " button.
2. Press the
3. Press " PROGRAM / CLOCK-ADJ. " button again to memorize the track.
4. Repeat steps 2 and 3 until all desired tracks are programmed.
5. Press the " PLAY/PAUSE " button to start. " PROGRAM " is shown on the CD display.
6. Press " STOP / CLEAR " button to stop programmed playback.
7. Press " PROGRAM / CLOCK-ADJ. " and " PLAY/PAUSE " buttons to resume programmed playback.
8. Press to go to the next programmed track.
9. Turn off the CD player to clear the programmed memory.
Note : Programming can only be made when the player is in stop mode.

MAINTENANCE

CLEANING CD
If the CD skips or will not play , the disc may need cleaning
. Before playing, wipe the disc from the center outward with a
cleaning cloth. After playing, store the disc in its case.
CLEANING THE CD LENS
If the CD lens is dusty, clean it with a brush-blower. Blow
several times on the lens and remove the dust with the
brush. Finger prints may be removed with a cotton swab
moistened with alcohol.
CD1E-CD-BIGBEN-GB-TCD07N.indd 7
skip buttons to select the desired track number.
GB 5
CD display
PROGRAM
CLEANING THE UNIT
Do not use volatile chemicals on this unit. Clean by lightly
wiping with a soft cloth.
IMPORTANT NOTE
If an abnormal display indication or an operating problem
occurs, disconnect the AC power cord. Wait at least 5
seconds, then reconnect the AC power cord.
WARNING
Should the CD door be opened before the reading of the CD
is completed, a jamming noise may occur. This is resolved
by closing the CD door.
2009/9/28 05:18:38