Installation Instructions; Dimensions; Safety Instructions For Installation; General Information - Zenner Multidata Wr3 Montage- Und Bedienungsanleitung

Installation instructions

Dimensions

Height:
Width:
Depth:
B

Safety instructions for installation

Read these instructions care-
fully right up to the end before
starting to mount the device! The
installation has to be done by
qualified professional personnel.
The current laws and regulations
have to be observed, especially EN
1434 part 1+6, (in Germany also
AGFW directive FW202, FW 218 and
FW 510). At devices with communi-
cation interfaces or mains supply
the general technical rules and the
correspondent regulations have to
be followed.
While demounting flow sensors
and temperature sensors make
sure no heating water escapes
from the pipe. This can cause
burns! Close valves and release
pressure before installation.
H = 106 mm
B = 126 mm
T = 54 mm

General information

Calculators for combined heating /
cooling meters can be recognized
at the imprint „change over" or
„Heating / Cooling" on the front of
the chassis.
Take care of:
The display must be readable at
■
all times.
To avoid malfunctions due
■
to other interferences do not
install fluorescent lamps, switch
cabinets or electric devices
such as motors or pumps in the
immediate vicinity of the meter
(minimum distance 1 m).
All welding must be finished.
■
The ambient temperature must
■
not exceed 55 °C.
The type of temperature sensor
■
must correspond with the
calculator.
The pulse value of the flow sen-
■
sor must correspond with the
one from the calculator.
21