Blaupunkt ESC608 Bedienungsanleitung Seite 8

ESC608
Description of buttons/features:
1. Power button: press and hold the power button to turn the power on/off;
2. Acceleration button: press the acceleration button to start and accelerate;
3. Brake: squeeze the brake lever to brake (the rear LED light shines stronger when braking)
4. Function button: press the function button to select the speed mode:
a. Start-up mode: The "S" icon lights up in white (the maximum speed is about 15 km/h)
b. Normal mode: the "S" icon lights up in yellow (the maximum speed is about 20 km/h)
c. Sport mode: the "S" icon lights up in red (the maximum speed is about 25 km/h)
5. LED lighting: Press the function button twice to turn the front and rear LED lights on; press the
function button twice again to turn the LED lights off.
6. Changing the speed unit: Press the function button three times to change the speed unit from
km/h to mph; press the function button again three times to restore the speed unit to km/h.
7. Cruise-control mode: maintain your current speed for approximately 6 seconds to enter the
cruise-control mode; then press the acceleration button or squeeze the brake lever to deactivate
the cruise control.
8. Warning light: Indicates that the controller temperature is too high. As soon as it appears on the
display and you hear a warning signal, stop riding immediately, switch off the scooter, and wait
until the controller cools down. Using the scooter with the light on can cause permanent damage
to the controller. This fault is not covered by the warranty.
Unpacking
After opening the cardboard box, first remove the scooter and
check that all parts are complete. If anything is missing, contact your dealer. Check the condition of
the equipment and its external appearance, then check whether the folding device is stable enough,
and that the platform has no cracks. Also check that the display screen is not damaged.
Assembly
After unpacking and checking the condition of all the components, the scooter can be assembled.
Follow the picture instructions below:
1. Assembly after removal from the packing
A
6
B