ASROCK Fatal1ty H97 Performance Serie Bedienungsanleitung Seite 31

All manuals and user guides at all-guides.com
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 22)
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis must
support HDA to function correctly. Please follow the instructions in our manual and
chassis manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to
connect them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel
and adjust "Recording Volume".
Chassis Speaker Header
(4-pin SPEAKER1)
(see p.1, No. 20)
Chassis and Power Fan
Connectors
(4-pin CHA_FAN1)
(see p.1, No. 13)
(3-pin CHA_FAN2)
(see p.1, No. 29)
(3-pin CHA_FAN3)
(see p.1, No. 28)
(3-pin PWR_FAN1)
(see p.1, No. 2)
This header is for
connecting audio devices
to the front audio panel.
Please connect the chassis
speaker to this header.
Please connect fan cables
to the fan connectors and
match the black wire to
the ground pin.
FAN_SPEED
FAN_VOLTAGE
GND
FAN_SPEED
+12V
GND
Fatal1ty H97 Performance Series
27