Operation - Arrow PT50 Benutzerhandbuch

Operation

APPLICATIONS
Including, but not limited to: insulation, roofing felt, house wrap, auto and marine vinyl
trim, cabinet felt, cabinet backs, screen door repair, small furniture, light trim, molding and
picture frames, and general staple use.
ADJUSTING THE EXHAUST
The adjustable exhaust on the cap of the tool allows users to direct
the exhaust according to operator preference. To adjust the direction,
turn the exhaust cap in the desired direction.
STAPLES
The Arrow PT50 Pneumatic Stapler is designed to use T50 heavy duty staples in size 1/4",
5/16", 3/8", 1/2", 17/32" and 9/16". For best results use genuine Arrow T50 staples.
AIR SUPPLY
This stapler is designed to operate on clean, dry, regulated compressed air, between
60 and 100 psi. It is preferable to include an air filter, pressure regulator, and automatic oiler
within 15 feet of the tool, if possible.
An air filter is needed to remove contaminates and moisture that are contained in
compressed air; filtering will significantly prolong the life of the tool. If an automatic oiler is
not installed, place 5 to 6 drops of oil into the tool's air inlet at the beginning of each work
day.
The staple gun comes factory-equipped with a male quick connector. The staple gun must
always be connected to the air supply with a coupling that removes all pressure
when it is disconnected.
NOTE: all components used with this staple gun (air hose, connectors, regulators,
filters, etc.) must be rated at 150 psi, OR 150% of the maximum compressor
potential, whichever is higher. Do not connect this staple gun to a system with
maximum potential air pressure greater than 200 psi.
AIR CONNECTION SETUP