Herunterladen Inhalt Inhalt Diese Seite drucken
Arrow PT50 Benutzerhandbuch

Arrow PT50 Benutzerhandbuch

Pneumatisches klammergerät
Vorschau ausblenden Andere Handbücher für PT50:
Inhaltsverzeichnis
Verfügbare Sprachen

Verfügbare Sprachen

1 Year Limited Warranty
Arrow Fastener Company warrants to the original consumer purchaser ("you") that this
product will be free from original defects in materials and workmanship for 1 year after
you purchase it. If the product does not comply with this warranty, Arrow will, at its
option, repair or replace the product with an equivalent product at no charge to you. This
warranty is not transferable. For best performance, use genuine Arrow staples. Arrow
staples are made to exact tolerances to insure trouble-free stapling performance. This
warranty does not cover defect or damage to the extent caused by the use of non Arrow
branded staples. This warranty also does not cover damage relating to normal wear and
tear, misuse, abuse, neglect, accident, natural disaster, or alteration of the product
without Arrow's consent. TO THE EXTENT PERMITTED BY LAW, ANY IMPLIED
WARRANTIES, INCLUDING ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE, ARE LIMITED TO THE SAME DURATION AS THIS EXPRESS
WARRANTY. Some states do not allow limitations on how long an implied warranty lasts,
so the above limitation may not apply to you. NO OTHER EXPRESS WARRANTY HAS
BEEN MADE OR WILL BE MADE BY ARROW WITH RESPECT TO THIS PRODUCT.
ARROW SHALL NOT BE RESPONSIBLE FOR SPECIAL, INCIDENTAL OR
CONSEQUENTIAL DAMAGES WHETHER ARISING OUT OF BREACH OF WARRANTY,
BREACH OF CONTRACT, TORT, OR OTHERWISE. Some states do not allow the exclusion
of incidental or consequential damages so the above exclusion and limitation may not
apply to you. This warranty gives you specific legal rights, and you also may have other
rights which vary from state to state. This guarantee does not affect your statutory rights.
In Canada, the above provisions are not intended to operate where prohibited by law and
do not preclude the operation of any applicable provincial consumer protection statute
which may in certain circumstances extend the express warranty herein. To obtain the
benefits of this warranty, you must send the product securely packaged with proof of
purchase and postage prepaid to:
Arrow Fastener Co., LLC
271 Mayhill Street, Saddle Brook, N.J. 07663 U.S.A.
PNEUMATIC STAPLE GUN
INSTRUCTION MANUAL
Important Information. Please read carefully before use.
www.arrowfastener.com
OM-2000
Rev 513
Inhaltsverzeichnis
loading

Inhaltszusammenfassung für Arrow PT50

  • Seite 13 Kaufdatum, dass dieses Produkt frei von ursprünglichen Fehlern in Material und PNEUMATISCHES KLAMMERGERÄT Verarbeitung ist. Wenn das Produkt dieser Garantie nicht genügt, wird Arrow, nach seiner Wahl, das Produkt kostenfrei reparieren oder mit einem gleichwertigen Produkt austauschen. Diese Garantie ist nicht übertragbar. Für beste Ergebnisse, Original-Arrow- Klammern verwenden.
  • Seite 14: Allgemeine Sicherheitsregeln

    Allgemeine Sicherheitsregeln Allgemeine Sicherheitsregeln PERSÖNLICHE SICHERHEIT ARBEITSORT Stets Augenschutz tragen. Benutzer und andere am Arbeitsort sollten stets Arbeitsplatz sauber und hell halten. Unfallgefahr bei zu vollen Werkbänken und dunklen ANSI-geprüfte Sicherheitsbrillen mit Seitenschild tragen. Der Augenschutz ist zum Orten. Schutz gegen herumfliegende Befestiger und Späne zu nutzen, welche ernste Augenschäden verursachen können.
  • Seite 15: Bedienung

    VERWENDUNG DES KLAMMERGERÄTS Dieses Klammergerät ist zum Betrieb mit sauberer, trockener, regulierter Druckluft PT50 hat einen Kontakt-Sicherheitstaster; zum richtigen Gebrauch, ist der Auslöser daher zwischen 60 und 100 psi ausgelegt. Es ist zu bevorzugen, einen Luftfilter, fest gegen die Oberfläche zu drücken. Sobald Kontakt-Sicherheitstaster effektiv gegen die Druckregulator und automatischen Öler möglichst innerhalb von 15 Fuß...
  • Seite 16: Spezifikationen

    PT50™ Skizze & Teile-Liste Spezifikationen Klammer-Typ/Größe: Feuert 6 Größen von Arrow T50 Klammern 1/4" (6mm), 5/16" (8mm), 3/8" (10mm), 1/2" (12mm), 17/32" (13mm), 9/16" (14mm) Pistolenkörper-Gehäuse: Druckguss, mit pulverbeschichteter Oberfläche Handgriff: Gummiüberzug auf Griffbereich Auslöser-Typ: Spritzgussplastik-Auslöser für ergonomischere Bedienung Betriebsdruck:...

Inhaltsverzeichnis