Important Safety Precautions; Directions For Use - PALSON Thor Gebrauchsanleitung

GB
Our products are developed to meet the highest quality, performance and design standards. We hope you enjoy your
new PALSON Thor electric meat mincer.

IMPORTANT SAFETY PRECAUTIONS

When using electrical appliances, certain basic safety precautions must be followed, including the following:
- Read all of the instructions before using.
- To prevent electric shocks, do not immerse the unit, the power cord or the plug in water or other liquids.
- Any appliance should be watched carefully when it is used by or near children.
- Unplug from the mains socket when it is not being used, before assembling or disassembling parts, and before
cleaning.
- Avoid contact with moving parts. Never push the food with your hand. Always use a food pusher.
- Never use any appliance with a damaged power cord or plug, or after a malfunction, or when it has been dropped
or damaged. Take the appliance to your nearest authorised technical service centre for inspection, repair or
mechanical or electrical adjustment.
- This appliance should only be used with the attachments supplied.
- Using attachments not recommended or sold by the appliance's manufacturer may cause a fire, electric shock or
injury.
- Do not use outdoors.
- Do not allow the power cord to hang over the edge of a table or counter or touch hot surfaces.
- To prevent any risk of cuts, do not use your fingers to remove food from the cutting disc while the appliance is
operating.
- This appliance is designed for domestic use only. Any servicing other than cleaning and maintenance by the user
must be carried out by an authorised technical service representative.
- Do not immerse the unit in water.
- In order to reduce the risk of fire or electric shock, do not disassemble the base. There are no user-repairable parts
inside it. Repairs must be carried out solely by authorised technical service personnel.
- In order to prevent damage, do not try to mince bones, nutshells or other hard items.
- This product must not be used by children or by other people without assistance or supervision if their physical,
sensory or mental condition limits safe use of the appliance. Children must be watched to make sure that they do
not play with the appliance.
- If the power cord is damaged, it must be replaced by the manufacturer or its authorised technical service centre or
by a qualified technician in order to avoid hazards.
ASSEMBLY
1 Insert the feeding screw in the mincing tube with the long end of the shaft first.
2 Position the cutting blade on the feeding screw with the flat cutting surfaces facing you.
3 Place the required mesh plate on the feeding screw against the flat surfaces of the cutting blade.
Make sure that the mesh plate notches fit in the mincing tube grooves.
4 Fasten tightly the threaded ring to the end of the mincing tube.
5 Insert the mincer head in the opening of the motor unit. Turn slowly and push until it fits firmly in position. Note: It
may be necessary to loosen the locking knob to enable full insertion of the mincer head.
6 Fasten the mincer head by turning the locking knob until it is tight.
7 Place the feeding hopper on the feeding tube.
8 Use the food pusher to gently push the food, one piece at a time, into the tube. Do not force food into it.

DIRECTIONS FOR USE

- Place the assembled appliance on a stable work surface, so that the ventilation holes on the base and rear of the
appliance are not blocked.
- Make sure that the on/off switch is in the "off" position. Insert the plug in the mains socket.
6