Hardware Installation; Configuring The Device; Software Installation - LevelOne WAP-6221 Schnellinstallationsanleitung

Hardware Installation

Power on the Device.
l Plug one end of your Ethernet cable into the WAN port of the AP, and the other end
into a port on a PoE switch or a 802.3af PoE adapter.

Configuring the Device

To set up and manage the AP, you can use one of the following methods:
l Connect the access point and your computer to the same PoE switch. Manage the
access point from the computer. (Figure 1)

Software Installation

To login to the LevelOne AP, please perform the following steps:
1. Check Your Network Settings to login web UI.
Please make sure your PC can get IP address automatically, so the router can
communicate with your PC during configuration.
l Select "Control Panel" > "Network Connections".
l Right click the "Local Area Connection" and choose "Properties".
l Select the TCP/IP protocol for your network card.
l Change the IP Address of PC: To configure the IP Address, click the network icon to
open the Ethernet dialog to configure the IP Address. Select "Properties", choose
"Internet Protocol (TCP/IP)" and select "Properties". Input the IP Address
"192.168.188.2 ~ 192.168.188.250" and continue. (Figure 2)
2. Launch a Web browser (Microsoft Internet Explorer 8 for example), enter the AP's
default LAN IP address 192.168.188.253 in the address bar, and then press Enter,
as shown in the following picture. (Figure 3)
3. Then enter the default user name of admin and password of admin in the User
Name and Password fields, click "OK" to access the AP's Web GUI. (Figure 4)
-4-