Teac CD-532EK Handbuch Seite 30

If the mounting rails are necessary for installation in a personal
computer, contact the personal computer maker or dealer.
Note:
Be sure to use mounting screws provided. If longer than specified
screw is used, the CD-532E may be damaged.
(2) Confirm the bus slot of the personal computer, then determine the
appropriate slot for the IDE interface card and remove the blank
panel fixed to the rear of the slot. Reuse the screw to mount the
Interface card.
(3) Fully insert the IDE interface card into the slot, then secure the
card using the blank output panel screw.
Interface card
Note:
If your system is equipped with an onboard controller, you will not
need the interface card.
30
Mounting screw
3. Connection to a Personal Computer