Teac CD-532EK Handbuch Seite 28

With S2 open (jumper not set) the TEAC CD-532E ist set to single
or slave mode by setting the jumpers S3 and S4. The set mode is
irrespective of the CSEL signal. Master/slave mode is determined
by CSEL if S2 is shorted (jumper set). In this case S3 and S4 are
irrespective for setting the mode.
Note:
When setting modes using these straps, be sure to switch off the
CD-ROM drive before doing so.
S2 S3
X
– X
–
Remark:
28
S4 Remarks
The modes Master or Slave are determined
? ?
by the signal CSEL.
– Slave
Master (DASP signal is used to determine
– X
the master/slave mode).
X: Strap shorted
–: Strap open
2. Controls and Functions