Werbung
Verfügbare Sprachen
Verfügbare Sprachen
®
PolyMount
PLASTER COAT OVER EXPANDED METAL LATH ON STEEL STUDS, HOLLOW TILE, HOLLOWBLOCK:
Drill 5/8" (16 mm)holes. Broach the holes in hard materials to allow for the toggle wing to pass through. Insert screws
through Wall Channel holes then affix the toggle wings to the screws. Insert toggle wings into previously drilled holes.
Use a level to make sure the channel is vertical prior to final seating of the screws.
CONCRETE WALLS:
REFER TO QUALIFIED PERSONNEL. Contact GCX for concrete installation addendum.
THROUGH WALL, BACK TO BACK INSTALLATIONS:
Sufficient length 1/4-20 machine screws, nuts, washers and/or back plates must be obtained to mount the channel by
drilling all the way through the thin partition wall. If two channels are to be mounted back to back, internally threaded
sleeves, exact length screws and specific procedures are available from GCX upon request. A Portalign drill fixture is
recommended for this procedure.
SPECIAL APPLICATIONS:
Channels can be attached to a GCX 4" X 4" (10.16 x 10.16 CM), 1/8" (3.17 mm) wall aluminum support column or certain
mullions, etc.. Contact GCX to discuss solutions to wall mounting problems for any situation not covered by these
guidelines.
ALTHOUGH CONSIDERABLE EFFORT HAS BEEN MADE TO ENSURE THE SAFETY OF THE ABOVE
INSTALLATION AND/OR GUIDELINES, THE INSTALLATION ITSELF IS BEYOND THE CONTROL OF GCX
CORPORATION. ACCORDINGLY, GCX CORPORATION WILL NOT BE RESPONSIBLE FOR THE FAILURE OF ANY
SUCH INSTALLATION.
FOR ADDITIONAL INFORMATION, PLEASE CONTACT:
GCX Corporation
3875 Cypress Drive
Petaluma, CA 94954-5635
707.773.1100
800.228.2555 US/CAN
Fax: 707.773.1180
E-mail: sales@gcx.com
Web: www.gcx.com
GCX, POLYMOUNT, POLYQUIP AND POWERMOUNT ARE REGISTERED TRADEMARKS OF GCX CORPORATION.
CONFIDENTIAL MATERIAL
© 1987 GCX CORPORATION ALL RIGHTS RESERVED
THIS MATERIAL IS THE PROPRIETARY INFORMATION OF GCX CORPORATION AND ANY USE, REPRODUCTION, OR DISTRIBUTION OF THE MATERIAL CONTAINED HEREIN, UNLESS
SPECIFICALLY AUTHORIZED BY GCX CORPORATION IS EXPRESSLY FORBIDDEN AND WOULD VIOLATE THE RIGHTS AND INTERESTS OF GCX CORPORATION.
THE MAXIMUM LOAD RATING FOR THIS SYSTEM IS 80 lbs. / 36 Kg
(VB SERIES PRODUCTS) OR 110 lbs. / 50 Kg (FT SERIES PRODUCTS)
DU-WC-0001-I-20 Rev B 1/7/00 Page 4 of 28
Werbung
