Reggiani YORI SUPERFICIE Installations- Und Montageanweisungen Seite 7

YORI SUPERFICIE | ENG |
ASSEMBLY INSTRUCTIONS
FOR YORI WARNINGS
Before assembling the luminaire, care-
fully read these instructions to make sure
the luminaire functions correctly and sa-
fely.
Keep the instructions in a safe place for
future consultation; contact your supplier
for any problems that may arise.
The luminaire must not be modifi ed. Mo-
difying the luminaire in any way invalida-
tes the guarantee of conformity with stan-
dards and directives in force and it could
make the actual luminaire hazardous.
Reggiani SPA Illuminazione shall not be
held liable for any damage caused by one
of its luminaires if not assembled in con-
formity to the following instructions.
The luminaire must be installed in accor-
dance with the best working standards.
Before connecting the luminaire, make
sure the mains power supply corresponds
to the power indicated on the luminaire
label.
The electrical installation the luminaire is
connected to must be wired in conformity
to the laws in force.
As a safety guarantee, any components
damaged while operating must be repla-
www.reggiani.net
ced with the same components before the
luminaire is used again.
The minimum distance between the
projector and the lighted object must
be 0.5 m for LEDs.
Never cover the projector during use.
Never use abrasives or solvents to
clean the glass and/or the shields.
PREPARATION AND ASSEM-
BLY OF THE LUMINAIRES
To assemble the projector.
Turn the electricity off at the
mains and follow the instructions
in the photographs below
ADJUSTABLE LED LUMINAI-
RES WITH STANDARD EXTER-
NAL DIMMER
The luminaires in the LED family can be
used with an external remote control and/
or 1...10V analogue dimmer (if required),
guaranteeing 10 % to 100 % adjustment of
the nominal value. The maximum number
of luminaires that can be controlled simul-
taneously depends on the control device
07