Husqvarna PP 70 Montage- Und Bedienungsanweisung Seite 8

2. Connect the outlet water connector on the product to
the power tool.
3. To adjust the flow of water coolant to the power tool,
refer to the operator's manual for the power tool.
4. Adjust the water pressure at the water source.
To connect a power tool to the product
1. Remove the cover (A).
B
A
2. Connect the power tool to the outlet for tool
connection (B). If it is necessary, use an adapter.
Adapters on page 14 .
Refer to
To start the product
1. Make sure that the machine stop button is
disengaged. Refer to
stop button on page 6 .
8
To do a check of the machine
2. Push the ON button (A) to start the product.
A
To stop the product
1. Stop the connected power tool. Refer to the
Operator's manual for the power tool.
2. Push the OFF button (B) to stop the product.
B
1244 - 002 -