Werbung
IMPORTANT
Greenhouses
Anchoring
Kit
for: Harmony, Hybrid, Mythos, Octave,
Balance, Essence
PALRAM's
Greenhouse Greenhouses
Please read
these
instructions carefully before you start to assemble this product.
Please
carry
out the
steps
in
the order
set
out
in
these instructions.
Keep these
instructions
in
a
safe
place
for future
reference.
Before you
stare
It
is
highly recommended to
be assisted by
a
second person
in
some steps.
Sort the parts and check according to the contents parts list.
The
product must
be
positioned
and fixed on
a
leveled surface.
Make sure
that
screws and anchors suit
the surface type.
Please be safe
during
assembly.
Safety
IRThis
product should
be
mounted to the ground
as
shown
in
these
instructions
in
order to
ensure greenhouse's
stability
and appropriate wind resistance.
'-N,
Some parts may have sharp edges. Please be careful when
handling
components.
RAlways
wear gloves,
eye
protection,
and long sleeves when assembling or
performing
any maintenance on
your product.
RtIf
using
a
stepladder
or power tools please ensure
that
you
follow
the
manufacturer's safety advice.
IRDo
not
lean
the stepladder against the greenhouse.
IRDo
not
stand on the greenhouse roof/panels
IRTo
prevent injuries, do not allow children to
play
under the greenhouse
during
assembly.
IRDo
not attempt to
assemble the greenhouse
in
windy
or
wet conditions
You
will
need
To
assembly
this product
(these items
not supplied)
AI
Care
and Maintenance
0
Periodically check the
product
to
assure
that
it remains stable.
0
Keep
roof
clean
of
snow.
Durina Assembly
P
During assembly you will encounter the information
icon, please
refer
to the relevant assembly
step for
additional comments
and
assistance.
Step
4
:
cable should not
be
placed over the
window
vent,
in
order not to
block
window
opening
Step
5
:
According to the ground surface type,
follow
the appropriate
mounting
procedure.
Option
1
:
soft/ground installation.
Option
2
:
for
hard surfaces (concrete or wood)
Step
7
:
After the product
has
been installed, fasten the steel cable by
turning part #7332
Tighten
all screws
when completing assembly.
It
is
possible
to cut the
rest
of
the
steel cable
only after
a
final decision
on
the mounting location
has
been made.
Werbung
